IEC 62535-2008 PDF

IEC 62535-2008 PDF

Insulating liquids-Test method for detection of potentially corrosive sulphur in used and unused insulating oil

$50.44 $100.88 -50%
Product Code: IEC 62535
Stock In Stock
Edition: 1.0
Published: 10/2008
Number of Pages: 36
File Size: 1 file, 923 Bytes

Available Options

Product Description

Insulating liquids – Test method for detection of potentially corrosive sulphur in used and unused insulating oil

Introduction: In recent years, several failures of transformers and reactors due to copper sulphide formation in/on the cellulose insulation have been reported worldwide. The tendency of transformer oils to form copper sulphide in the presence of copper is seen as one of the major contributing factors. The most common reason for such failures is arcing between adjacent disks or conductors of a winding, due to the formation of deposits of copper sulphide on the cellulosic insulating paper. It has been demonstrated that existing test methods for corrosive sulphur, ASTM D1275 method A and DIN 51353, are unable to detect oils having potentially corrosive behaviour. For this reason, IEC technical committee 10 has prepared this International Standard for the detection of potentially corrosive sulphur in mineral insulating oils. The wrapped conductor test method is suitable for used and unused mineral oils. This test method is based on a study performed by Conseil International des Grands Réseaux Electriques (CIGRE) working group A2.32 [1]1. Health and safety This International Standard does not purport to address all the safety problems associated with its use. It is the responsibility of the user of the standard to establish appropriate health and safety practices and determine the applicability of regulatory limitations prior to use. The mineral oils which are the subject of this standard should be handled with due regard to personal hygiene. Direct contact with eyes may cause slight irritatio

Scope: This International Standard specifies a test method for detection of potentially corrosive sulphur in used and unused mineral insulating oil. Most recent failures due to corrosive sulphur are related to the formation of copper sulphide deposits in and on the surface of winding cellulosic paper. The test method uses a copper conductor, wrapped with one layer of paper, immersed in the oil and heated to evaluate the capability of the oil to yield copper sulphide and transfer it to paper layers. The growth of copper sulphide on bare copper may cause the presence of conductive particulates in the oil, which can act as nuclei for electrical discharge and may lead to a fault. Other test methods exist using a bare copper strip immersed in oil and heated to detect the corrosive behaviour of oil against copper. ASTM D1275 Method B is also used for this test and a modified procedure using low oil volumes is included in Annex A. Tests with and without paper are considered as complementary and may lead to different results.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62535-2008 PDF

IEC 62535-2008 PDF

$50.44 $100.88