Radio frequency (RF) bulk acoustic wave (BAW) filters of assessed quality – Part 1: Generic specification
Introduction: RF BAW filters are now widely used in mobile communications. While the RF BAW filters have various specifications, many of them can be classified within a few fundamental categories. Standard specifications, given in the IEC 62575 series, and national specifications or detail specifications issued by manufacturers, define the available combinations of nominal frequency pass bandwidth, ripple, shape factor, terminating impedance, etc. These specifications are compiled to include a wide range of RF BAW filters with standardized performances. It cannot be over-emphasized that the user should, wherever possible, select his RF BAW filters from these specifications, when available, even if it may lead to making small modifications to his circuit to enable standard filters to be used. This applies particularly to the selection of the nominal frequency. This standard has been compiled in response to a generally expressed desire on the part of both users and manufacturers for guidance on the use of RF BAW filters, so that the filters may be used to their best advantage. To this end, general and fundamental characteristics have been explained in this part of IEC 62575. It is not the aim of this standard to explain theory, nor to attempt to cover all the eventualities which may arise in practical circumstances. This standard draws attention to some of the more fundamental questions, which should be considered by the user before he places an order for an RF BAW filter for a new applicati
Scope: This part of IEC 62575 specifies the methods of test and general requirements for RF BAW filters of assessed quality using either capability approval or qualification approval procedures. Conventional crystal filters standardized in the IEC 60368 series are not covered by this standard.
Contents:
- FOREWORD
- INTRODUCTION
- Scope