Railway applications – Electronic power converters for fixed installations – Part 1: General requirements
Introduction: Semiconductor converters for traction power supply differ from other converters for industrial use due to special electrical service conditions and due to the large range of load variation and the peculiar characteristics of the load. For these reasons the IEC 60146 series does not fully cover the requirements of railway applications and the decision was taken to have a specific series of standards for this use. Specific requirements for the design of converter transformers for fixed installations of railway applications are specified in IEC 62695. This document defines common vocabulary and requirements. Other parts will cover different applications. The whole series is listed below. Requirements in the specific parts have priority over this document. IEC 62590-1, Railway applications – Electronic Power Converters for fixed installations – Part 1: General requirements IEC 62590-2-1, Railway applications – Electronic Power Converters for fixed installations – Part 2-1: DC traction applications – Uncontrolled rectifiers IEC 62590-2-2, Railway applications – Electronic Power Converters for fixed installations – Part 2-2: DC traction applications – Controlled converters IEC 62590-3-1, Railway applications – Fixed installations – Electronic power converters – Part 3-1: AC traction applications – Electronic power compensators IEC 62590-3-2, Railway applications – Electronic Power Converters for fixed installations – Part 3-2: AC traction applications – Static frequency converters
Scope: This part of IEC 62590 specifies the common requirements and definitions for all power converter applications in fixed installations for power supply of railway systems. This document applies to fixed installations of following electric traction systems: railway networks, metropolitan transport networks including metros, tramways, trolleybuses and fully automated transport systems, magnetic levitated transport systems, electric road systems. This document applies to AC/DC converters, DC converters and AC converters. Converters for improvement of power quality and for energy saving are also included. Converters connected to electric traction systems feeding 3AC, 1AC or DC systems for auxiliary purpose are not in the scope of this document but some aspects such as insulation coordination and railway specific conditions can be referred to.
Contents:
- FOREWORD
- INTRODUCTION
- Scope