Railway applications – Fixed installations – Electronic power converters for substations
Introduction: Semiconductor converters for traction power supply differ from other converters for industrial use due to special electrical service conditions and due to the large range of load variation and the peculiar characteristics of the load. For these reasons IEC 60146-1-1 does not fully cover the requirements of railway applications and the decision was taken to have a specific standard for this use. Converter transformers for fixed installations of railway applications are covered by EN 50329 IEC 62695. Harmonization of the rated values and tests of the whole converter group are covered by IEC 62589.
Scope: This document specifies the requirements for the performance of all fixed installations electronic power converters, using controllable and/or non-controllable electronic valves, intended for traction power supply. The devices can be controlled by means of current, voltage or light. Non-bistable devices are assumed to be operated in the switched mode. This document applies to fixed installations of the following electric traction systems: railways, guided mass transport systems such as: tramways, light rail systems, elevated and underground railways, mountain railways, trolleybusses. This document does not apply to: cranes, transportable platforms and similar transportation equipment on rails, suspended cable cars, funicular railways. This document applies to diode rectifiers, controlled rectifiers, DC converters, inverters and frequency converters. The equipment covered in this document is the converter itself.
Contents:
- FOREWORD
- INTRODUCTION
- Scope