IEC 62677-3-101-2018 PDF

IEC 62677-3-101-2018 PDF

Heat-shrinkable low and medium voltage moulded shapes-Part 3: Specification for individual materials-Sheet 101: Heat-shrinkable, polyolefin moulded shapes for low voltage applications

$25.22 $50.44 -50%
Product Code: IEC 62677-3-101
Stock In Stock
Edition: 1.0
Published: 01/2018
Number of Pages: 26
File Size: 1 file, 364 Bytes

Available Options

Product Description

Heat-shrinkable low and medium voltage moulded shapes – Part 3: Specification for individual materials – Sheet 101: Heat-shrinkable, polyolefin moulded shapes for low voltage applications

Introduction: This part of IEC 62677 is one of a series that deals with heat shrinkable low and medium voltage moulded shapes. The series consists of three parts: Part 1: General requirements (IEC 62677-1); Part 2: Methods of test (IEC 62677-2); Part 3: Specification for individual materials (IEC 62677-3). This standard gives one of the sheets comprising Part 3 as follows: Sheet 101: Heat-shrinkable, polyolefin moulded shapes for low voltage applications Sheet 102: Heat-shrinkable, polyolefin, anti-tracking moulded shapes for medium voltage applications Sheet 103: Heat-shrinkable, polyolefin, semi-conductive moulded shapes for 8 medium voltage applications

Scope: This part of IEC 62677 is applicable to heat shrinkable low voltage moulded shapes in a range of configurations suitable for insulation, environmental sealing, mechanical protection, strain relief for power cable terminations, joints and stop ends. These moulded shapes have been found suitable for use for temperatures between –40 °C and 100 °C. The moulded shapes can be supplied with a pre-coated adhesive. A guide to adhesive compatibility and temperature performance is given in Annex A. The manufacturers/suppliers can be consulted for options. The material is available in two types: Type A – Flame retardant Type B – Not flame retardant Materials which conform to this document meet established levels of performance. However, the selection of a material by a user for a specific application will be based on the actual requirements necessary for adequate performance in that application and will not be based on this document alone. The tests specified are designed to control the quality of the moulded shapes but it is recognized that they are designed to be used in low and medium voltage cable accessories and, as such, electrical performance will be proven as part of the assembly. Examples of this are described in EN 50393, HD 629 and IEC 60502-1.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62677-3-101-2018 PDF

IEC 62677-3-101-2018 PDF

$25.22 $50.44