IEC 62715-5-3-2017 PDF

IEC 62715-5-3-2017 PDF

Flexible display devices - Part 5-3: Visual assessment of image quality and defects

$132.41 $264.81 -50%
Product Code: IEC 62715-5-3
Stock In Stock
Edition: 1.0
Published: 05/2017
Number of Pages: 32
File Size: 1 file, 762 Bytes

Available Options

Product Description

Flexible display devices - Part 5-3: Visual assessment of image quality and defects

Introduction: This part of IEC 62715 was developed in response to demands for the standardization of the general rules and detailed procedures that are used in the visual assessment of flexible display devices. Visual assessment is an essential means for evaluating flexible display devices and is intended to complement objective display measurements [1] 1 . The advantages of visual assessment are as follows: a) It is speedy, e.g. defects are instantly recognized by a human observer. b) It allows the evaluation of various device shapes and allows evaluation from various directions and distances, which can lead to higher sensitivity for detecting defects. c) It completely covers the area of even the largest display, allowing identification and selection of regions of interest for objective measurements. d) It is sensitive, e.g. for some defects, visual assessment is the most sensitive means of detection. e) It corresponds to the perception of humans. f) It can detect unexpected changes or defects that can be overlooked by predetermined measurements with equipment. Visual assessment is a necessary first step for specifying types of measurements and the regions of interest for measurements. Evaluation results from visual assessment depend on the observer, region of interest for the assessment, lighting and geometrical conditions of the assessment, criteria in making judgments, and various other factors. Therefore, it is important to standardize the general rules, including the terms, condition

Scope: This part of IEC 62715 provides the framework and procedures for performing the visual assessment of flexible display devices. Visual assessment stipulated in this document is applicable to flexible display modules in the following states: initial states and ageing states under standard ambient conditions, mechanically or environmentally stressed conditions, states after mechanical endurance test(s), after environmental endurance test(s) and after a combination of mechanical and environmental endurance tests. NOTE Visual assessment under the mechanical or environmental stress is usually difficult to do, but this document can be applied when it is possible. Visual assessment is performed by comparing a test sample to a limit sample or to a set of grade samples. This document provides the framework and procedures for visual assessments that use a limit sample or a set of grade samples. This document describes the framework and procedure that are followed while preparing limit samples and a set of grade samples. This document also describes visual assessment when limit samples and grade samples are not available for the same type of defect. This document provides sets of test patterns that can be used in visual assessments.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62715-5-3-2017 PDF

IEC 62715-5-3-2017 PDF

$132.41 $264.81