IEC 62752-2024 PDF

IEC 62752-2024 PDF

In-cable control and protection device (IC-CPD) for mode 2 charging of electric road vehicles

$299.49 $598.97 -50%
Product Code: IEC 62752
Stock In Stock
Edition: 2.0
Published: 03/2024
Number of Pages: 328
File Size: 1 file, 6 Bytes

Available Options

Product Description

In-cable control and protection device (IC-CPD) for mode 2 charging of electric road vehicles

Introduction: The essential purpose of this document is the safe and reliable access of electric vehicles to a supply system. The definition for "mode 2 charging of electric vehicle" is described in IEC 61851-1. For all charging modes, protection against electric shock in case of failure of basic protection and/or fault protection is provided, at least by a type A residual current device (RCD) (see IEC 60364-7-722 and IEC 61851-1). For mode 2 charging, including the situation where it cannot be guaranteed that the installation is equipped with RCDs, for example charging the electric vehicle at an unknown installation, a dedicated protection is used for the connected electric vehicle. The intention of this document is to describe the relevant requirements for an in-cable control and protection device (IC-CPD) to be used for mode 2 charging. This version of IEC 62752 covers also the content of the former IEC 62335.

Scope: This International Standard applies to in-cable control and protection devices (IC-CPDs) for mode 2 charging of electric road vehicles, hereafter referred to as "IC-CPD", including control and safety functions. This document applies to portable devices performing simultaneously the functions of detection of the residual current, of comparison of the value of this current with the residual operating value and of opening of the protected circuit when the residual current exceeds this value. The IC-CPD according to this document provides a control pilot function in accordance with IEC 61851-1:2017, Annex A; checks supply conditions and prevents charging in the event of supply faults under specified conditions; can have a switched protective conductor. Residual currents with frequencies different from the rated frequency, DC residual currents and specific environmental situations are considered. This document is applicable to IC-CPDs performing the safety and control functions as required in IEC 61851-1 for mode 2 charging of electric vehicles. This document is applicable to IC-CPDs for single-phase circuits not exceeding 250 V or multi-phase circuits not exceeding 480 V, their maximum rated current being 32 A. This document is applicable to IC-CPDs to be used in AC circuits only, with preferred values of rated frequency 50 Hz, 60 Hz or 50/60 Hz. IC-CPDs according to this document are not intended to be used for bidirectional or reverse power transfer, feeding back energy to the system for distribution of electricity. This document is applicable to IC-CPDs having a rated residual operating current not exceeding 30 mA and which are intended to provide additional protection for the circuit downstream of the IC-CPD as it cannot be guaranteed that the upstream installation is equipped with an RCD rated I∆n ≤ 30 mA. The IC-CPD consists of: a plug for connection to a socket-outlet in the fixed installation; one or more subassemblies containing the control and protection features; a cable between the plug and the subassemblies (optional); a cable between the subassemblies and the vehicle connector (optional); a vehicle connector for connection to the electric vehicle. For

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62752-2024 PDF

IEC 62752-2024 PDF

$299.49 $598.97