Measurement procedures for materials used in photovoltaic modules - Part 2-1: Polymeric materials - Frontsheet and backsheet - Safety requirements
Introduction: This document provides test procedures and specifications for polymeric front- and backsheet constructions employed in a PV module for safety qualification on a component level. Test methods have been compiled to match the general requirements for polymeric materials used as relied-upon insulation defined in the IEC 61730 standard series in consideration of test methods in IEC TS 62788-2 (characterization of front- and backsheets), IEC TS 62788-7-2 [4]1(UV weathering test) and the retesting guidelines IEC TS 62915. This document provides clarifications on definitions of front- and backsheet construction types and related test requirements, and additional environmental stress testing, to which IEC 61730-1 refers. Separating out the component level testing into this document was considered to limit the complexity of the IEC 61730 standard series, also in view of the implementation of the test methods in the frame of IEC System of Conformity Assessment Schemes for Electrotechnical Equipment and Components (IECEE). Test methods on a component level and PV module level are different for practical reasons. On a component level, the daylight filtered xenon test (IEC TS 62788-7-2) is applied for UV weathering, which is regarded as more representative to assess the durability of polymeric materials under outdoor weather conditions than the UVA test of IEC 61215-2. The latter has been developed in view of practicality of applying UV exposure to larger scale PV modules. This document fo
Scope: This document specifies the safety requirements for flexible polymeric front- and backsheet constructions, which are intended for use as relied-upon insulation in photovoltaic (PV) modules. The specifications in this document define the specific requirements of polymeric front- or backsheet constructions on the component level and cover mechanical, electrical, visual and thermal characterization in an unexposed state and/or after ageing. This document covers class II and class 0 modules, as defined in IEC 61730-1. Class III modules are out of scope. For qualification to IEC 61730-1 of a PV module using a polymeric front- or backsheet, the sheet must pass the requirements in this document for the specified module’s safety class, rated system voltage, and module temperature rating. Compliance with the safety requirements for a front- or backsheet on the component level does not replace the need for a safety qualification of the complete PV module, in which the front- or backsheet is integrated. The appropriate requirements for testing and qualification of PV modules, are defined in IEC 61730-1 and IEC 61215-1 (or IEC TS 62915 in case of retesting), with test methods provided by IEC 61730-2 and IEC 61215-2, respectively. This document provides the requirements for qualification of front- and backsheets to be used in module safety qualification according to IEC 61730-1. Test method descriptions are provided in IEC TS 62788-2, along with additional characterization methods useful for performance or quality assurance.
Contents:
- FOREWORD
- INTRODUCTION
- Scope