Transmitting and receiving equipment for radiocommunication – Frequency response of optical-to-electric conversion device in high-frequency radio-over-fibre systems – Part 2: Measurement method of common-mode rejection ratio of optical coherent detection device for radio-over-fibre transmitter
Introduction: A variety of photonic devices operated in microwave and millimetre-wave bands are useful for an optical fibre transport system as well as wireless communication and broadcasting systems. An optical-to-electric conversion device including an optical receiver plays as an interface, which converts an optical signal into an electrical signal directly. Microwave and millimetre-wave radio-over-fibre (RoF) systems are comprised mainly of two parts: an RF to photonic converter (E/O) and a photonic to RF converter (O/E). Radio waves are converted into an optical signal at the E/O, and the signal is transferred through the optical fibre, and then the radio waves are regenerated at the O/E. A variety of photonic devices which carry microwave and millimeter-wave signals at subcarrier frequencies are used for high-frequency RoF systems. In high-frequency RoF systems such as millimetre-wave band radio signal transfer systems, the specifications of conversion efficiency and its frequency response have been important technical parameters, and therefore, the IEC 62803 series has been developed. Nowadays, the coherent optical fibre network system is used widely, namely in core and metro networks with a capacity greater than 100 Gbit/s/ch. Finally, cost and performance have improved. In this coherent optical fibre network system, an optical coherent detection device, which is comprised of an optical 90° hybrid coupler and balanced photodetectors, provides an IQ separation in an optical domain f
Scope: This part of IEC 62803 provides the measurement method of the common-mode rejection ratio of optical coherent detection devices in high-speed RoF systems, as well as in high-speed optical signal transmission systems. In addition, the method is also effective for the estimation of the detailed frequency response of the common-mode rejection ratios and O/E conversion efficiency. The method applies for the following: frequency range: 1 GHz to 110 GHz; wavelength band: 0,8 µm to 2,0 µm. The use of optical coherent detection devices for high-speed RoF system is shown in Annex A as an example.
Contents:
- FOREWORD
- INTRODUCTION
- Scope