IEC 62811-2015 PDF

IEC 62811-2015 PDF

AC and/or DC-supplied electronic controlgear for discharge lamps (excluding fluorescent lamps)-Performance requirements for low frequency square wave operation

$163.93 $327.86 -50%
Product Code: IEC 62811
Stock In Stock
Edition: 1.0
Published: 04/2015
Number of Pages: 72
File Size: 1 file, 668 Bytes

Available Options

Product Description

AC and/or DC-supplied electronic controlgear for discharge lamps (excluding fluorescent lamps) – Performance requirements for low frequency square wave operation

Introduction: This International Standard covers performance requirements for electronic controlgear for use on a.c., at 50 Hz or 60 Hz and/or d.c. supplies up to 1 000 V associated with discharge lamps as specified in IEC 61167 for low frequency square wave operation. In order to obtain satisfactory performance of discharge lamps and electronic controlgears, it is necessary that certain features of their design be properly coordinated. It is essential, therefore, that specifications for them be written in terms of measurement made against some common baseline of reference, permanent and reproducible. These conditions may be fulfilled by reference ballasts. Moreover, the testing of controlgear for discharge lamps will, in general, be made with reference lamps and, in particular, by comparing the results obtained using these lamps on the controlgear to be tested and on the reference ballast. Whereas the reference ballast for frequencies of 50 Hz or 60 Hz is a self- inductive coil, the low frequency square wave reference ballast is a resistor because of its independence of frequency and the lack of influence of parasitic capacitance.

Scope: This International Standard specifies performance requirements for electronic controlgear for use on a.c. and/or d.c. supplies up to 1 000 V and/or a.c. supplies up to 1 000 V at 50 Hz or 60 Hz, associated with discharge lamps, as specified in IEC 61167, which have information for low frequency square wave operation, where the frequency range of the low frequency is from 70 Hz to 400 Hz. Tests in this standard are type tests. Requirements for testing individual controlgear during production are not included. There are regional standards regarding the regulation of mains current harmonics and immunity for end products like luminaires and independent controlgear. In a luminaire, the controlgear is dominant in this respect. Controlgear, together with other components, should comply with these standards.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62811-2015 PDF

IEC 62811-2015 PDF

$163.93 $327.86