Electric motor-operated hand-held tools, transportable tools and lawn and garden machinery – Safety – Part 2-16: Particular requirements for hand-held fastener driving tools (Extended Version)
Introduction: Individual countries may wish to consider the application of this Part 1 of IEC 62841, so far as is reasonable, to tools not mentioned in an individual part of IEC 62841-2, IEC 62841-3 or IEC 62841-4 and to tools designed on new principles. Examples of standards dealing with non-safety aspects of hand-held tools, transportable tools and lawn and garden machinery are standards dealing with EMC aspects; standards dealing with environmental aspects.
Scope: This International Standard deals with the safety of electric motor-operated or magnetically driven: hand-held tools (IEC 62841-2); transportable tools (IEC 62841-3); lawn and garden machinery (IEC 62841-4). The above listed categories are hereinafter referred to as “tools” or “machines”. The rated voltage is not more than 250 V for single-phase a.c. or d.c. tools, and 480 V for three-phase a.c. tools. The rated input is not more than 3 700 W. The limits for the applicability of this standard for battery tools are given in K.1 and L.1. This standard deals with the hazards presented by tools which are encountered by all persons in the normal use and reasonably foreseeable misuse of the tools. Tools with electric heating elements are within the scope of this standard. Requirements for motors not isolated from the supply, and having basic insulation not designed for the rated voltage of the tools, are given in Annex B. Requirements for rechargeable battery-powered motor-operated or magnetically driven tools and the battery packs for such tools are given in Annex K. Requirements for such tools that are also operated and/or charged directly from the mains or a non-isolated source are given in Annex L. Hand-held electric tools, which can be mounted on a support or working stand for use as fixed tools without any alteration of the tool itself, are within the scope of this standard and such combination of a hand-held tool and a support is considered to be a transportable tool and thus covered by the relevant Part 3. This document applies to hand-held fastener driving tools intended for driving fasteners into or through concrete, fabric, fiberboard, metal, plastic, wood, wood products, cartons, and other materials; and whose energy to drive the fastener is derived directly or indirectly from an electric motor or magnetic drive. This document does not apply to pneumatically driven tools where the compressed gas comes from an external source, such as a compressor or a tank. This document does not apply to tools powered by combustible gases, even if electrically ignited. NOTE 101 Tools powered by compressed air or combustible gases are covered by ISO 11148-13:2017. This sta
Contents:
- FOREWORD
- INTRODUCTION
- Scope