IEC 62896-2024 PDF

IEC 62896-2024 PDF

Hybrid insulators for AC and DC for high-voltage applications greater than 1 000 V AC and 1 500 V DC-Definitions, test methods and acceptance criteria

$100.88 $201.76 -50%
Product Code: IEC 62896
Stock In Stock
Edition: 1.0
Published: 05/2024
Number of Pages: 46
File Size: 1 file, 1000 Bytes

Available Options

Product Description

Hybrid insulators for AC and DC for high-voltage applications greater than 1 000 V AC and 1 500 V DC – Definitions, test methods and acceptance criteria

Introduction: Hybrid insulators consist of an insulating core, bearing the mechanical load protected by a polymeric housing, the load being transmitted to the core by end fittings. Despite these common features, the materials used and the construction details employed by different manufacturers may be quite different. The core is made of ceramic or glass material. Hybrid insulators are applied as overhead line, post or hollow core equipment insulators. In order to perform the design tests, IEC 62217 is intended to be applied for the polymeric housing and the interfaces between core and the housing. For the core, the test standards for the respective ceramic product (IEC 60168, IEC 60383-1 and −2 and IEC 62155) are intended to be applied. Some tests have been grouped together as "design tests", to be performed only once on insulators which satisfy the same design conditions. For all design tests of hybrid insulators, the common clauses defined in IEC 62217 are applied. As far as practical, the influence of time on the electrical and mechanical properties of the components (core material, housing, interfaces etc.) and of the complete hybrid insulators has been considered in specifying the design tests to ensure a satisfactory life-time under normally known stress conditions in service. Polymeric housing materials that show the hydrophobicity transfer mechanism (HTM) are preferred for hybrid insulators. These housing materials are applied as a countermeasure against severely polluted service

Scope: This document applies to hybrid insulators for AC and DC applications greater than 1 000 V AC and 1 500 V DC consisting of a load-bearing insulating solid or hollow core consisting of ceramic or glass, a housing (defined geometry, outside the insulating core) made of polymeric material and end fittings permanently attached to the insulating core. Hybrid insulators covered by this document are intended for use as suspension/tension long rod and cap and pin type insulators, line post insulators, station post insulators and hollow core insulators for apparatus. The object of this document is to: define the terms used; prescribe test methods; prescribe acceptance criteria. Silicone or other functional coatings (CIGRE Technical Brochure No. 478), booster sheds, shed extenders and rain deflectors are not within the scope of this document. CIGRE B2.69 published two Technical Brochures, TB 837 and TB 838, in June 2021 with the scope of practical applications and collection of experiences for anti-pollution coatings for insulators. This document does not include requirements dealing with the choice of insulators for specific operating conditions.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62896-2024 PDF

IEC 62896-2024 PDF

$100.88 $201.76