Printed electronics – Part 302-6: Equipment – Inkjet – First drop measurement
Introduction: Drop-on-demand inkjet printing has been used as a manufacturing tool for printed electronics. The use of inkjet has many advantages since an exact amount of droplets can be deposited on target locations without wasting excessive amount of materials. To position the inkjet head on the printing location, jetting from the inkjet head should be paused for a while. As a result, it has been well known that the initial first few drops, after the non-jetting pause time, can be different from that of the steady state jetting. The abnormal behaviours of the first few drops can cause serious printing quality problems. Also, it could produce poor yield when used in manufacturing process. So, the proper evaluation of first-drop failures has been important steps for inkjet process development. Moreover, substrates can be unloaded and loaded for printing, especially in printed electronics applications. By using a fiducial camera to view the substrate, the printing target position in the substrate is identified via alignment marks on substrates. Also, the substrate should be aligned with respect to motion stage axes prior to printing. It can take considerable time and the jetting should not occur during the preparation for printing. Due to the non-jetting period, ink on the nozzle surface can dry, and consequently the jetting behaviours of the first few drops are likely to differ from those of steady-state jetting. If the abnormal jetting behaviour is significant, printing quality can be aff
Scope: This part of IEC 62899 specifies the method for determining inkjet first drop behaviour based on either visualized droplet images or printed dots on standard substrate. The exact behaviour that is referenced in this document is as follows: jetting speed variation according to the drop numbers, including non-jetting and low jetting speed. This measurement standardization is limited to drop-on-demand type of inkjet including piezo and thermal types and is not applicable to continuous inkjet. This document includes the test equipment, printing procedures, and analysis of drop behaviour. This document is limited to printed electronics application and is not suitable for graphic or other applications.
Contents:
- FOREWORD
- INTRODUCTION
- Scope