Printed electronics - Part 402-8: Printability - Measurement of qualities - Shape pattern dimension
Introduction: This document specifies the measurement of dimensions of the shape patterns in printed electronics. The shape patterns include various patterns with shapes such as circle, ellipse, square, rectangle, etc., as well as a combination of two or more of these, which are commonly used as parts of printed electronics devices. Various shape patterns constitute printed electronics devices, and consequently, the printability of patterns including dimension, gain, loss and distortion affects device performance. Therefore, it is important to measure the dimensions of shape patterns from the viewpoint of printability. Some parts of pattern measurement have been specified for line pattern width, edge, and voids in IEC 62899-402-1, IEC 62899-402-2, and IEC 62899-402-3, respectively. The IEC 62899-403 series includes basic patterns for evaluation of printing machine, basic patterns for plating, etc., and moreover, IEC 62899-301-2 deals with the measurement of plate master pattern dimension. However, there is no standard for the measurement of printed patterns with general shapes. Therefore, this document is used to measure the dimensions of printed patterns as the result of the pattern design of the IEC 62899-403 series and plate patterns of IEC 62899-301-2 as well as to compare the dimensions of printed patterns with the pattern design for evaluating the printability. This document includes two methods for the measurement of dimensions of the shape patterns: The first one is to simply speci
Scope: This part of IEC 62899 specifies the measurement methods of the dimensions of the shape patterns in printed electronics. These printed patterns are treated as two-dimensional on a substrate. When the patterns are definitely affected by three-dimensional configurations, these are specified in measurement methods for vertical variance in IEC TR 62899-402-4 in printed electronics. NOTE The measurement methods of dimensions of the shape patterns considering three-dimensional characteristics can be developed later after the measurement methods for vertical variance are established.
Contents:
- FOREWORD
- INTRODUCTION
- Scope