Insulating liquids – Unused modified or blended esters for electrotechnical applications
Introduction: Electrical insulation and heat transfer are essential functions of insulating liquids for electrotechnical applications. Until recently, these liquids have been normally homogeneous, selected from different categories, such as most common mineral oils or newer synthetic esters, natural esters or silicone liquids. The continuous research for improvement of performance characteristics of equipment drives an interest in exploring benefits from combinations of liquids. Some known examples of desired improved characteristics include optimized liquid cost, increased cooling performance, improved flash point, extended insulation life or reduced environmental impacts. Currently, international standards exist for specifically defined liquid categories (mineral oils, synthetic esters, natural esters, silicone liquids). None of them cover chemically modified natural ester liquids or blends of various esters. Moreover, the existing standards do not cover synthetic esters whose characteristics may go beyond the limits defined in IEC 61099. Some modified esters or their blends are already available as commercial products by liquid suppliers. Examples are: Palm fatty acid ester with low viscosity of 5 mm2/s at 40 °C and with flash point of 176 °C. Blend of triglycerides (50 %) and monoesters (50 %) with low viscosity of 17 mm2/s at 40 °C and with flash point of 200 °C. The number of sources for ester liquids or their blends is expected to grow over the coming years. Such liquids need to be
Scope: This document defines requirements for the characterization of unused modified esters or blends of unused esters used as insulating liquids for electrotechnical applications. It does not cover liquids that contain any proportion of used liquids. The liquids covered by this document are intended mainly for transformer applications. Unused modified/synthetized esters are derived from a natural or synthetic base, or are blends of both. This document covers a variety of ester liquids not covered by other standards specific to natural esters (IEC 62770) or synthetic esters (IEC 61099). As it addresses various categories of liquids, this document also covers a wide range of values for certain performance characteristics. An important property is viscosity, which can affect the design and cooling performance of electrical equipment. A categorization is defined based on the kinematic viscosity of the different liquids. The category of low viscosity ester liquids is established.
Contents:
- FOREWORD
- INTRODUCTION
- Scope