Home and building electronic systems (HBES) and building automation and control systems (BACS) – Part 3: Electrical safety requirements
Introduction: The IEC 63044 series deals with developing and testing Home and Building Electronic Systems (HBES) and Building Automation and Control Systems (BACS). This document deals with electrical safety requirements for HBES/BACS. This document is based on the philosophy that a device considered electrically safe according to an appropriate product safety standard should also remain safe when connected to a network. This document specifies in addition to the specific product standard the electrical safety requirements necessary in order for an HBES/BACS device connected to a network to remain safe under normal and single-fault conditions of the HBES/BACS network and at the same time under normal and single-fault conditions of one or more HBES/BACS devices connected to the HBES/BACS network. This includes protection from overvoltages on the network, protection from hazards caused by connection of different types of circuit network, the limitation of the touch current to a network and protection of the communication wiring from overheating. The HBES/BACS network is any interconnection between HBES/BACS products devices. The HBES/BACS networks can be either an ICT network with interfaces classified according to IEC 62949 or a dedicated network classified as a mains, ELV, FELV, SELV or PELV circuit network. For HBES/BACS products devices connected to an ICT network, the requirements in IEC 62949 apply. For HBES/BACS products devices connected to a dedicated HBES/BACS network, the requirem
Scope: This part of IEC 63044 provides the electrical safety requirements related to the HBES/BACS network in addition to the product safety standards for HBES/BACS devices. It also applies to devices used within an HBES/BACS network for which no specific HBES/BACS product safety standard exists. This document specifies the electrical safety requirements for HBES/BACS. In addition, it defines safety requirements for the interface of equipment intended to be connected to an HBES/BACS network. It does not apply to interfaces to other networks. NOTE An example of other networks is a dedicated ICT network covered by IEC 62949. This document is applicable to operator stations and other human–system interface devices, devices for management functions, control devices, automation stations and application-specific controllers, field devices and their interfaces, and cabling and interconnection of devices used within a dedicated HBES/BACS network. This document covers the following requirements and compliance criteria: protection from against hazards in from the device; protection from against overvoltages on the network; protection from against touch current; protection from against hazards caused by different types of circuit network; protection of the communication wiring from against overheating caused by excessive current.
Contents:
- FOREWORD
- INTRODUCTION
- Scope