Ferrite cores – Guidelines on dimensions and the limits of surface irregularities – Part 1: General specification
Introduction: Due to the method of manufacture and the physical nature of the products, ferrite cores can be expected to exhibit some degree of physical irregularities such as chips, ragged edges, cracks, flashing, and pull-outs. The permissible extent of these surface irregularities will depend on the type, position and size of the defect and on the function of the core. Thus, in order to establish limits of surface irregularities for a given series of ferrite cores, for example RM-cores, pot-cores, E-cores, U- cores and ring-cores, a particular specification should be prepared for each, setting out in detail the permissible extent of the various types of irregularities. All surfaces of the core should be clean and free from loose ferrite particles or any other foreign matter. This is more critical for mating surfaces that should make good contact with one another. Stains, discolorations, surface crazing or crystallization are acceptable if they do not affect the normal performance of the core. The irregularities described below are considered as being detectable without the use of any magnifying equipment. The limits of surface irregularities are set for control of the cosmetic appearance, and not for control of the magnetic performance. Surface irregularities do not substantially affect core magnetic function, nor do they affect reliability. Reliability should be assessed for wound magnetics, rather than for cores alone. See IEC 60401-3 for more details concerning the reliability of fer
Scope: This part of IEC 63093 specifies the dimensions and allowable limits of surface irregularities of ferrite cores. It is intended that this document includes ferrite cores which are widely used and referenced in industry, either because they are included in national standards, or because they are seen to have broad-based use in industry. Where applicable, it is intended that the existing industrial name for each standard part appears with the part within this series. It is intended that this document excludes ferrite cores which are specialty cores with limited use. Also, special cores which are only marginal variations upon standard cores are excluded. A ferrite core produced by only one or two suppliers can generally be considered a specialty part, and not suitable as a standard core within this series. A ferrite core produced by three or more competing manufacturers can generally be considered to be a candidate to be included in this series. IEC publishes electrical standards for families of ferrite cores, as well as this series of dimensional standards for families of ferrite cores. Modifications to the ferrite cores listed in one type of standard are reflected in the other type. This document is considered as a general specification useful in the dialogue between ferrite core suppliers and users about surface irregularities.
Contents:
- FOREWORD
- INTRODUCTION
- Scope