Determination of inrush current characteristics of lighting products
Introduction: Inrush current is the transient current drawn by an electrical device after it is switched on via an independent mains switch, the maximum amplitude of which is often much higher than in steady state during normal operation. Inrush current occurs because of charging capacitances during power up of a device. Quantities such as peak inrush current and inrush current pulse duration are key parameters to characterize the inrush current, which are important to consider when selecting the switchgear of a lighting installation. This information is indispensable for electric installation planners, lighting designers and installers to be able to guarantee compatibility of a lighting system with other installation components like switches and overcurrent protection devices. Careful selection of overcurrent protection devices, like circuit breakers, is important when dealing with high inrush currents. The overcurrent protection should react quickly to overload or short circuit but should not interrupt the circuit when an inrush current flows (i.e. false tripping). Another unwanted adverse effect that could occur when inrush current is not considered is welding of contacts of mechanical or electromechanical switches (manual or automatic). The aim of this document is to determine the peak inrush current and the inrush current pulse duration of one or multiple lighting products of the same type. This can serve as valuable information for installers in making the correct selection of compon
Scope: This document describes a method, based on measurements combined with calculations, to determine specific characteristics of the inrush current of single and/or multiple lighting products of the same type. Lighting products include the following: light sources with integrated controlgear, controlgear, luminaires. The inrush current characteristics that are determined are the peak inrush current, the inrush current pulse duration. This document applies to lighting products connected to low-voltage 230 V AC 50/60 Hz electrical supply networks. NOTE In Clause 6 it is stated that the methodology applies reference values for the reference (line) inductance and the reference (short circuit) peak current which reflect the typical situation in a 230 V AC installation.
Contents:
- FOREWORD
- INTRODUCTION
- Scope