IEC CISPR TR 30-1-2012 PDF

IEC CISPR TR 30-1-2012 PDF

Test method on electromagnetic emissions-Part 1: Electronic control gear for single- and double-capped fluorescent lamps

$72.51 $145.02 -50%
Product Code: IEC CISPR TR 30-1
Stock In Stock
Edition: 1.0
Published: 08/2012
Number of Pages: 24
File Size: 1 file, 382 Bytes

Available Options

Product Description

Test method on electromagnetic emissions – Part 1: Electronic control gear for single- and double-capped fluorescent lamps

Introduction: Requirements to limit radio-frequency disturbances from lighting equipment are standardized in CISPR 15. They are restricted to those kinds of lighting equipment which are considered as finished products and intended to be placed on the market for the end user, viz. luminaires, self-ballasted lamps and independent lamp control gear. No emission requirements apply to components intended to be built into luminaires. Most electronic control gear for lamps (tubular fluorescent, low voltages halogen incandescent lamps or HID-lamps) are built into a number of different types of luminaires: not only in luminaires of different manufacturers but also in different types of luminaires of one manufacturer. All those luminaires are tested, although disturbance data of a certain luminaire can be predicted from other luminaire measurements equipped with the same electronic control gear and lamps. This has led to the question whether a worst-case test luminaire could be designed in which the electronic control gear could be tested. In the event that this test luminaire complies with the relevant requirements, all luminaires where that particular electronic control gear is built in comply, and a great deal of superfluous testing can be avoided. This idea looks correct, simple and interesting, but leads to two comments: a worst-case luminaire is too strict. From pre-measurements it appeared that commercial electronic control gear did not pass some tests in a worst-case dummy luminaire, whereas

Scope: This part of CISPR 30, which is a technical report, details, with the aid of reference luminaires, an independent method by which the radio disturbance characteristics of electronic control gear for fluorescent lamp luminaires with protection classes I and/or II may be compared against the requirements of CISPR 15. This technical report covers electronic control gear for double-capped fluorescent lamps fitted with G5 or G13 lamp caps and to single-capped fluorescent lamps fitted with lamp caps: 2GX7, 2G8, 2G10, 2G11, 2GX13, G23, GX23, G24q, GX24q, GR8, and GR10q. NOTE The above listing shows a typical selection of caps which are commonly used and does not lay claim to be exhaustive. It is specifically applicable for equipment to be connected to 230 V – 50 Hz mains power networks. For other power systems, modifications may be necessary.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC CISPR TR 30-1-2012 PDF

IEC CISPR TR 30-1-2012 PDF

$72.51 $145.02