Guidelines for defining halogen content terminology in IEC standards
Introduction: IEC and other standards development organizations (SDOs), as well as numerous environmental performance programmes worldwide (such as Blue Angel in Europe and EPEAT in the US), are developing standards for the determination, quantification, and possible limitation of halogen content in materials and products. There are multiple reasons for such interest in the use and amounts of elemental halogens and certain halogenated compounds in materials and products, including: the health and safety of workers and end users; the safety of people, animals and goods in the event of fire; the minimization of adverse environmental impacts; the demonstration of compliance with product legislation; business and commercial interests. NOTE 1 The list above is not prioritized by level of importance. NOTE 2 More information about fire retardancy in relation to halogens is provided in Clause B.2. An analysis of standards developed by different IEC committees reveals differences in terminology, and differences in the halogens concerned and their associated threshold (see Annex A). Similar differences are also observed with respect to other standards such as regional (CEN, CENELEC, UL), national (IPC, JEDEC) and sectorial publications (e.g. in the railways domain). The definitions related to halogen content in standards developed by IEC and other SDOs exhibit differences such as the following (see more details in Annex A). Different terms like halogen-free, non-halogenated, zero-halogen, and low-ha
Scope: This Guide raises awareness and provides recommendation on the use of consistent terminology related to halogen content for use in horizontal and product-specific IEC standards. The terminology related to halogen content provided in this Guide does not take into consideration astatine (At) and the artificially created tennessine (Ts), since they are not used in electrical and electronic equipment (EEE). Diatomic halogen molecules (F2, Cl2, Br2, I2), normally not found in EEE, are also excluded from the terminology recommended in this Guide. NOTE The IEC Standardization Management Board (SMB) has decided that Guides such as this one can have mandatory requirements which shall be followed by all IEC committees developing technical work that falls within the scope of the Guide, as well as guidance which may or may not be followed. The mandatory requirements in this Guide are identified by the use of "shall". Statements that are only for guidance are identified by using the verb "should". (See ISO/IEC Directives, IEC Supplement:2021, A.1.1.).
Contents:
- FOREWORD
- INTRODUCTION
- Scope