IEC/IEEE 60076-16 (REDLINE + STANDARD)-2018 PDF

IEC/IEEE 60076-16 (REDLINE + STANDARD)-2018 PDF

Power transformers-Part 16: Transformers for wind turbine applications

$171.50 $342.99 -50%
Product Code: IEC/IEEE 60076-16 (REDLINE + STANDARD)
Stock In Stock
Edition: 2.0
Published: 09/2018
Number of Pages: 76
File Size: 1 file, 1.5 MB

Available Options

Product Description

Power transformers – Part 16: Transformers for wind turbine applications

Introduction: This part of IEC 60076 is intended to specify the additional requirements for the transformers for installation in wind turbine applications. Wind turbines use generator step-up transformers to connect the turbines to a network. These transformers can be installed in the nacelle or in the tower or outside close to the wind turbine. This standard covers transformers for wind turbine applications or wind farms where the constraints on transformers exceed the requirement of the present IEC 60076 series. The constraints are not often known or recognized by the transformer manufacturers, wind turbine manufacturers and operators and as a result the level of reliability of these transformers can be lower than those used for conventional applications. The transformers for wind turbine applications are not included in the present list of IEC 60076 standard series. The purpose of this standard is help to obtain the same level of reliability as transformers for more common applications. This standard deals particularly with the effects of repeated high frequency transient over- voltages, electrical, environmental, thermal, loading, installation and maintenance conditions that are specific for wind turbines or wind farms. On site measurements, investigations and observations in wind turbines have detected risks for some different kind of installations: repeated high frequency transient over or under voltages in the range of kHz; over and under frequency due to turbine control; values of

Scope: This part of IEC 60076 applies to dry-type and liquid-immersed transformers for rated power 100 kVA up to 10 000 kVA for wind turbine step-up applications having a winding with highest voltage for equipment up to and including 36 72,5 kV and at least one winding operating at a voltage greater than 1,1 kV. This document applies to the transformer used to connect the wind turbine generator to the wind farm power collection system or adjacent distribution network and not the transformer used to connect several wind turbines to a distribution or transmission network. Transformers covered by this document comply with the relevant requirements prescribed in the IEC 60076 standards or IEEE C57 standards.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC/IEEE 60076-16 (REDLINE + STANDARD)-2018 PDF

IEC/IEEE 60076-16 (REDLINE + STANDARD)-2018 PDF

$171.50 $342.99