IEC/IEEE 60255-118-1-2018 PDF

IEC/IEEE 60255-118-1-2018 PDF

Measuring relays and protection equipment - Part 118-1: Synchrophasor for power systems - Measurements

$239.59 $479.18 -50%
Product Code: IEC/IEEE 60255-118-1
Stock In Stock
Edition: 1.0
Published: 12/2018
Number of Pages: 78
File Size: 1 file, 2 Bytes

Available Options

Product Description

Measuring relays and protection equipment - Part 118-1: Synchrophasor for power systems - Measurements

Introduction: This document provides continuation and further development of previous synchrophasor standards, notably the IEEE C37.118 series. It defines synchrophasor, frequency, and rate of change of frequency (ROCOF) measurements as used in this technology. These definitions are in agreement with most research on and analysis of dynamic electric power system measurements, but may differ from those given in other contexts. Function and performance requirements are given for synchrophasor measurements. Tests, evaluation criteria, and error limits are provided to determine compliance with the requirements. Informative Annexes A, B, C, F, and H provide details about timing aspects, definition application and derivations, PMU measurements, generator power angle, and environmental tests. Informative Annex D details the M and P class reference models used to ensure the requirements can be met; these models are for limit qualification only, as it is expected that most real implementations will perform better than these models. Informative Annex E proposes revised performance requirements for synchrophasors produced from sampled values. These may be used as a basis for normative requirements in a future standard revision. Normative Annexes G and I provide optional qualification of extended steady-state accuracy and measurement bandwidth determination. A phasor measurement unit (PMU) estimates the parameters magnitude, phase angle, frequency, and rate of change of frequency from the signals appe

Scope: This part of IEC 60255 is for synchronized phasor measurement systems in power systems. It defines a synchronized phasor (synchrophasor), frequency, and rate of change of frequency measurements. It describes time tag and synchronization requirements for measurement of all three of these quantities. It specifies methods for evaluating these measurements and requirements for compliance with the standard under both static and dynamic conditions. It defines a phasor measurement unit (PMU), which can be a stand-alone physical unit or a functional unit within another physical unit. This document does not specify hardware, software or a method for computing phasors, frequency, or rate of change of frequency.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC/IEEE 60255-118-1-2018 PDF

IEC/IEEE 60255-118-1-2018 PDF

$239.59 $479.18