Electromagnetic compatibility (EMC) - Part 1-7: General - Power factor in single-phase systems under non-sinusoidal conditions
Introduction: 0.1 Series overview IEC 61000 is published in separate parts, according to the following structure: Part 1: General General considerations (introduction, fundamental principles) Definitions, terminology Part 2: Environment Description levels Classification of the environment Compatibility levels Part 3: Limits Emission limits Immunity limits (in so far as they do not fall under the responsibility of the product committees) Part 4: Testing and measurement techniques Measurement techniques Testing techniques Part 5: Installation and mitigation guidelines Installation guidelines Mitigation methods and devices Part 6: Generic standards Part 9: Miscellaneous Each part is further subdivided into sections which are to be published either as international standards, technical specifications, or as technical reports. These standards and reports will be published in chronological order and numbered accordingly (for example, 61000-6-1). 0.2 Purpose of this document The prevalence of loads drawing non-sinusoidal current from power systems requires clarification of such concepts as power and power factor, in order to avoid confusion due to
Scope: This part of IEC 61000, which is a Technical Report, provides definitions of various electrical power quantities and the relationship between them under non-sinusoidal conditions, in order to give clear information on both components in the power factor: the fundamental power factor, which is due to the phase difference between the voltage and current at the fundamental frequency, and the non-fundamental power factor, which is related to the distortion of the voltage and/or current. This Technical Report is applicable only to single- phase systems. This Technical Report provides definitions for the three following cases: the general case where the voltage and current are both distorted (Clause 5), the case where the voltage is assumed to be sinusoidal and the current is only distorted with harmonic components (Clause 6), the particular case where the voltage and current are both sinusoidal (Annex A). Annex B gives information on the fundamental active factor, which is used to describe the behaviour of a piece of equipment as a load or a generator.
Contents:
- FOREWORD
- INTRODUCTION
- 0.1 Series overview
- 0.2 Purpose of this document
- Scope