IEC TR 61912-2-2009 PDF

IEC TR 61912-2-2009 PDF

Low-voltage switchgear and controlgear-Over-current protective devices-Part 2: Selectivity under over-current conditions

$163.93 $327.86 -50%
Product Code: IEC TR 61912-2
Stock In Stock
Edition: 1.0
Published: 05/2009
Number of Pages: 38
File Size: 1 file, 1 Byte

Available Options

Product Description

Low-voltage switchgear and controlgear – Over-current protective devices – Part 2: Selectivity under over-current conditions

Introduction: Low-voltage equipment standards IEC 60947, IEC 60269, IEC 60898-1 and IEC 61009-1 currently include operating characteristics for over-current protective devices, defined in terms of the ability of the equipment to operate at levels of over-current up to their maximum short- circuit current ratings. In practice, the installation of such devices in series requires consideration of the relationship between the device characteristics to achieve the optimum in supply availability in the event of an over-current causing operation of any device. The ability of an over-current device to perform selectively in combination with other such devices needs to be fully understood by the circuit designer to avoid leaving a circuit vulnerable to unnecessary loss of supply, particularly where critical supplies are concerned. It is also useful to take full advantage of the capability of devices and systems to avoid over-engineering, with the consequent unnecessary additional cost. Selectivity over the whole range of fault current up to the prospective fault current at the point of installation is not always possible or necessary. A more economic solution may be found in many cases by accepting a limited selectivity, particularly taking into account the low probability of a high short-circuit fault current. Where a short-circuit protective device is used to provide back-up protection to a downstream device, guidance on the application is provided in IEC/TR 61912-1.

Scope: This technical report, which serves as an application guide for the determination of selectivity between over-current protective devices of low-voltage switchgear and controlgear, summarises the definitions of the terminology and provides examples of application. The following standards for devices are considered in this technical report: IEC 60255-3; IEC 60255-6; IEC 60255-8, IEC 60255-12 IEC 60269-1, IEC 60269-2, IEC 60269-3;IEC 60269-4; IEC 60898-1; IEC 60947 series; IEC 61008-1; IEC 61009-1. This report does not deal with other forms of protection, such as power-reversal protection, directional protection and arc-protection systems.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TR 61912-2-2009 PDF

IEC TR 61912-2-2009 PDF

$163.93 $327.86