Dynamic modules – Part 6-3: Round robin measurement results for group delay ripple of tunable dispersion compensators
Introduction: The most important means of enhancing the technology for communication systems are networking, faster speed, and longer distance. In long-distance, high-speed communication systems operating at 40 Gbps or more, dispersion is known to limit transmission distance. Various tunable dispersion compensators (TDCs) have been commercialized in order to minimize the degradation of signals caused by chromatic dispersion. However, the group delay (GD) in TDCs is known to have ripples dependent on the principles of TDC operation, and such GD affects signal degradation. IEC TC86 (Fibre optics) describes several methods of measuring chromatic dispersion (CD). One example is IEC 61300-3-38, but it does not specify a measurement method for group delay ripple (GDR). The representative passive component for compensating for chromatic dispersion is dispersion compensation fibre (DCF), but given its principles, the GD has no ripples. Conversely, many TDCs use the interference effect, which explains why there are ripples. Under these circumstances, round robin testing has been conducted by using various TDCs and diverse GD measurement methods. This technical report, based on the findings from round robin testing, examines the direction of standardization for GDR measurement methods. This technical report is based on and translated from OITDA document- TP06/SP DM-2008 (Group Delay Ripple Measurement Method for Tunable Dispersion Compensators-Technical Paper).
Scope: This technical report describes the round robin measurement results for the group delay ripple (GDR) of tunable dispersion compensators (TDCs). It briefly explains the four typical TDCs measured and four typical methods of measuring group delay (GD), as well as the GDR round robin measurement results of TDCs, and an analysis of repeatability and differences among these measurement methods. This technical report also proposes suitable measurement parameters and a new parameter of phase ripple instead of GDR.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 10 Conclusion