IEC TR 62517-2009 PDF

IEC TR 62517-2009 PDF

Magnetizing behaviour of permanent magnets

$72.51 $145.02 -50%
Product Code: IEC TR 62517
Stock In Stock
Edition: 1.0
Published: 04/2009
Number of Pages: 24
File Size: 1 file, 954 Bytes

Available Options

Product Description

Magnetizing behaviour of permanent magnets

Introduction: The full performance of a permanent magnet can only be obtained if it is magnetized properly to saturation. In IEC 60404-5 a definition of the saturation of a permanent magnet is given. Accordingly, a magnet is defined as saturated at a magnetizing field strength H1 if a 50 % higher field strength leads to an increase of (BH)max or HcB of less than 1 %. However, such a definition cannot explain the substantial differences in the magnetizing behaviour of modern permanent magnets which is mainly determined by their coercivity mechanisms. Unfortunately the variety of magnetizing behaviours cannot be accommodated by a simple recommendation such as “magnetize with magnetizing field strengths of three to five times the coercivity HcJ”. In particular for RE permanent magnets with high coercivity HcJ this simplification would lead to unacceptable overestimations of the required magnetizing field strengths.

Scope: It is within the scope of this technical report to describe the magnetizing behaviour of permanent magnets in detail. Firstly, in Clause 3 the relationship between the applied magnetic field strength and the effectively acting internal field strength is reviewed. In Clause 4 the initial state prior to magnetization is discussed. Then, in the main Clause 5, the magnetizing behaviour of all common types of permanent magnets is outlined. The clause is subdivided according to the dominant coercivity mechanisms, namely the nucleation type for sintered Ferrites, RE-Fe-B and SmCo5 magnets, the pinning type for carbon steel and Sm2Co17 1 magnets and the single domain type for nano-crystalline RE-Fe-B, Alnico and Cr- Fe-Co magnets. Finally, the recommended magnetizing field strengths for modern permanent magnets are compiled in a comprehensive table. Effective magnetizing field strength For magnetization of permanent magnets, the internal magnetic field strength Hint in the magnet is the critical parameter. The internal field strength is determined by the applied field strength Happl and the self-demagnetizing field strength Hdemag of the magnet or the magnet assembly. The self-demagnetizing field strength depends on the dimensions of the magnet or the load line of a magnet assembly and the polarization of the magnet material, see equation (1): Hint = Happl – Hdemag = Happl – N·J/μ0 (1) N denotes the demagnetization coefficient and J the polarization of the magnet material. Most advanced magnets are magnetized by a short pulse field, achieved by discharging a capacitor bank through a copper coil. The duration of the field pulse must last sufficiently long, in order to overcome the eddy currents at the surface of the magnets, in particular for large blocks. In general, a pulse duration of 5 ms to 10 ms is sufficient for complete penetration. The penetration depth λ , see equation (2), depends on the electrical resistance ρ, the permeability μ of the magnet material and the frequency f of the field pulse [1]2: λ = K (2) K denotes a constant. Preferably, magnets will be magnetized after assembly, since handling of unmagnetized magnets is easier and prevents contamination by

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TR 62517-2009 PDF

IEC TR 62517-2009 PDF

$72.51 $145.02