Ultrasonics – Conditioning of water for ultrasonic measurements
Introduction: Many ultrasonic measurements are conducted in water, as it provides an inexpensive and readily available medium with characteristic acoustic impedance comparable to biological tissue. However, basic tap water is far from optimum for ultrasonic measurement as it contains many dissolved, absorbed and suspended contaminants. Measurements can be affected in many ways by these impurities. For example: dissolved gases readily dissociate from the water in the presence of high rarefactional pressures or heat giving rise to bubble formation. These bubbles not only are unwanted point reflectors but also increase the likelihood of cavitation. dissolved ionic components result in a raised conductivity of the water, which in turn can affect the measured output from some unshielded hydrophones. Furthermore experimental equipment left in an ionic solution for any period of time will gradually develop a layer of deposit (e.g. calcium carbonate) on its surface. biological activity within an untreated water tank will result in the creation of an unpleasant film on all available surfaces. If left long enough this biological activity will result in an undesirable environment for the operator and may also be a health hazard. To minimize these effects it is necessary to undertake a water treatment process. These problems are well known and many IEC standards have sought to address these issues, often by means of an informative annex. This technical report aims to provide a unified resource for ope
Scope: This Technical Report describes methods: for degassing water to be used in ultrasonic measurements, to decrease the ionic content of water to be used in ultrasonic measurements, to decrease the biological content of water to be used in ultrasonic measurements, to reduce the suspended particulate content of water to be used in ultrasonic measurements. This technical report is applicable to all measurements of ultrasonic fields where water is the transmission medium. The quality and treatment methods for water used within a radiation force balance (RFB) may be different from that required for hydrophone based acoustic measurements. Chemical based methods of water treatment (e.g. algaecides) may be appropriate for these applications. However, in this document, chemical means are noted but appropriately discouraged for acoustic pressure/intensity measurements.
Contents:
- FOREWORD
- INTRODUCTION
- Scope