Guidance on clearances and creepage distances in particular for distances equal to or less than 2 mm – Test results of research on influencing parameters
Introduction: This document provides information on printed board assemblies and other equivalent plane arrangements of insulation, where the clearance and the creepage distance follows the same path along the surface of solid insulation. This document is based on German research data published in May 1989 [9], [10]1. SC 28A, the predecessor of TC 109, began analysing this research data in November 1990. The following points provide background information to the research. The research was carried out on test samples that were manufactured with the same technology being used for printed circuit boards (PCBs) with selected spacing of circuit patterns from 0,16 mm to 6,3 mm. Ten types of materials were used for the test samples. The influence of manufacturing operations on the surface of a material, for example moulding or machining, was not part of this research project. The test samples were placed in different locations, such as large city, rural, industrial, desert, sea side, and periodically exposed to a voltage stress and the data was accumulated over a long period of time. ____________ 1 Numbers in square brackets refer to the bibliography.
Scope: This document describes test results of research on dimensioning of clearances and creepage distances, for spacing equal to or less than 2 mm for printed wiring material and other equivalent arrangements of insulation, where the clearance and the creepage distance follows the same path along the surface of solid insulation. The information contained in this document is the result of research only and cannot be used for dimensioning the clearances and creepage distances for equipment within low-voltage systems, where IEC 60664-1 applies. However distances can be taken into account for functional reasons. This document provides results of research related to the following criteria: 1) clearances independent from the micro-environment; 2) creepage distances for pollution degree 1, 2 and 3 which extends the use of smaller distances to products having design features similar to printed circuit boards; 3) creepage distances to avoid flashover of the insulating surface; 4) information on minimum creepage distances to maintain minimum insulation resistance. A test method for the evaluation of the relevant water adsorption group for the surface of any insulating material which has not yet been classified is described.
Contents:
- FOREWORD
- INTRODUCTION
- Scope