IEC TR 63114-2018 PDF

IEC TR 63114-2018 PDF

Electrical steel-Reverse bend test method for electrical steel strip and sheet

$50.44 $100.88 -50%
Product Code: IEC TR 63114
Stock In Stock
Edition: 1.0
Published: 04/2018
Number of Pages: 20
File Size: 1 file, 478 Bytes

Available Options

Product Description

Electrical steel – Reverse bend test method for electrical steel strip and sheet

Introduction: Before the preparation of this document, the working group discussed the actual situation of industry concerning the application of reverse bend tests for the evaluation of the ductility of electrical steel strip and sheet, including non-oriented and grain-oriented materials. The following points were noted: The reverse bend test is widely used in industry for the evaluation of ductility of electrical steel, and is referenced by the products standards; In actual industry practice, the reverse bend test mainly uses as test specimens Epstein strips of 30 mm in width; The product standards of IEC 60404-8-4 [1] 1, IEC 60404-8-7 [2] and IEC 60404-8-8 [3] refer to ISO 7799 for the reverse bend test. However, ISO 7799 specified the width of test specimen to be less than the width of the Epstein strip (30 mm). Therefore, the Epstein strip does not meet with the requirement of ISO 7799; There are two modes for the reverse bend test, Europe generally adopts the method of reverse bend test according to ISO 7799 (defined as Mode A), alternatively America and Asia generally adopt that according to ASTM A720 [4] (for non-oriented materials) and JIS C2550 [5] (defined as Mode B), see also the references [6-7]; NOTE ASTM A721 [8] defined a bend method, which is different from the reverse bend test, to determine the ductility of grain-oriented materials. The apparatus and the requirements for the reverse bend test are slightly different between Mode A and Mode B, especially on the gap between

Scope: This Technical Report describes the general principle and technical details of the reverse bend test method used for evaluating the ductility of electrical steel strip and sheet. This test method is applicable to Epstein test strip specimens obtained from non-oriented and grain-oriented electrical steel of any grade. The test specimens shall not be annealed.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TR 63114-2018 PDF

IEC TR 63114-2018 PDF

$50.44 $100.88