Validation of dynamic power control and exposure time-averaging algorithms – Part 1: Cellular network implementations for SAR at frequencies up to 6 GHz
Introduction: The concept of dynamic power control and exposure time-averaging (DPC-ETA) has been introduced recently to enable wireless devices to maintain SAR compliance in real-time. DPC-ETA enables a SAR assessment that is more representative of the user exposure. The procedures in IEC/IEEE 62209-1528:2020 require device under test (DUT) to maintain a fixed output power and transmission duty factor during SAR measurement to establish the correct SAR distribution to determine SAR compliance. When devices are tested at a fixed maximum output power and transmission duty factor for worst-case exposure and continuous use, a reduction in maximum power is often necessary to satisfy SAR compliance. This can result in undesirable device performance with poor link budget and low data throughput. In DPC-ETA, SAR compliance is determined according to power recorded by the RF modem and time-averaged over a specified window duration. Device output power control is based on the linear SAR to power relationship established for a wireless operating mode and specific exposure condition to maintain SAR compliance during actual use. When the maximum time- averaged power is ensured by DPC-ETA, brief durations of higher instantaneous power can be applied while the maximum time-averaged power is not exceeded. NOTE 1 The time-averaging windows required by national regulations can be the same as those established for SAR limits or can differ and vary with frequency. The DPC-ETA algorithms are validated using p
Scope: This part of IEC 63424 describes the methods for validating dynamic power control and (dynamic) exposure time-averaging (DPC-ETA) algorithms used in RF modem chipsets of wireless devices. The DPC-ETA implementations are exposure-based, where SAR is time- averaged according to power recorded by the RF modem. Time-averaging windows up to six minutes consistent with applicable SAR limits and regulatory policies are considered for frequencies up to 6 GHz. The DPC-ETA power control parameters are established based on SAR compliance results with all relevant design and operating tolerances taken into consideration. The device output power is controlled by DPC-ETA to maintain SAR compliance in real-time. While SAR compliance is evaluated independently by applying IEC/IEEE 62209- 1528:2020 [1]1, this document contains information for algorithm validation. Quasi-static and dynamic power control test sequences are described in this document for algorithm validation. The test sequences are sent from a radio communication tester (RCT) and DPC-ETA responses are measured with conducted and radiated power measurement methods to confirm algorithm functionality. Test sequences for wireless configurations that need validation, including wireless mode transitions, call drop, handover, discontinuous transmission, and simultaneous transmission are described. Considerations for measurement automation to acquire time-aligned results for correlation with power changes in the test sequences are provided. DPC-ETA algorithms are validated by correlating the normalized power measurement results with the expected behaviours of an implementation for the applied test sequences. The procedures in this document also support algorithm validation of modular transmitters using an appropriate test platform. Guidance for using SAR methods in place of radiated power measurements and capacitive proximity sensor triggering with time-averaged detection are also included. NOTE 1 A separate document will be considered to validate DPC-ETA implementations above 6 GHz, according to near-field millimetre-wave band power density exposure requirements. Substantially shorter time-averaging window durations, on t
Contents:
- FOREWORD
- INTRODUCTION
- Scope