Insulation monitoring device - Marine AC application example
Introduction: The purpose of this document is to determine the values of the alarm thresholds of the insulation controller resulting from a loss of insulation of a device or a group of devices installed in an IT electrical system. IEC 60364-4-41:2005 and IEC 60364-4-41:2005/AMD1:2017 is dedicated to the safety of people, i.e. protection against electric shock. Subclause 411.6 is dedicated to the IT system. In cases where an IT system is used for reasons of continuity of supply, also in the event of an earth fault, an insulation monitoring device is used to indicate the occurrence of that first fault from a live part to exposed-conductive-parts or to earth. For onshore applications, the exposed-conductive-parts are connected to earth, either individually, in groups, or collectively to RA (see Figure 1). RA is the sum of the resistance in ohms of the earth electrode and protective earthing conductor PE (see IEC 60364-4-41:2005 and IEC 60364-4-41:2005/AMD1:2017, 411.6, and IEC 60364-1:2025, Figure 19). For marine applications, the exposed-conductive-parts are connected, either individually, in groups, or collectively to the hull. The protective conductors are either connected to the earthing bar of the switchboard or directly to the hull. For the purpose of this study of the alarm thresholds and touch voltage, the following is presumed: a) RA is the parameter to calculate at the fault point to find the touch voltage between exposed- conductive-parts of a faulty equipment and to the hull (not
Scope: This document explains the setting parameters of insulation monitoring devices (IMDs) and how to interpret these measurements through plotted curves. Some examples of injection methods are also proposed. NOTE 1 Requirements for IMDs are specified by IEC 61557-8. The examples given in this document consider the situation of an insulation fault in an installation or equipment (motors, enclosure, cables, etc.) creating a resistive path to earth and calculate the touch voltage. It does not consider a person making direct contact with a live conductor in an IT grid. NOTE 2 This document is informative and cannot contain requirements, in accordance with the ISO/IEC Directives, Part 2, for technical reports.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 1 500 Ω
- 1 500 Ω, 100 Ω, and 10 Ω, voltage system at 690 V
- 1 500 Ω, 13,2 kΩ, 100 kΩ) and 30 mA in Y axis at 690 V