Rotating electrical machines – Part 25: AC electrical machines used in power drive systems – Application guide (Commented Version)
Introduction: The performance characteristics and operating data for converter-fed electrical machines are influenced by the complete drive system, comprising supply system, converter, cabling, electrical machine, mechanical shafting and control equipment. Each of these components exists in numerous technical variants. Any values quoted in this document are thus indicative only. In view of the complex technical interrelations within the system and the variety of operating conditions, it is beyond the scope and object of this document to specify numerical or limiting values for all the quantities which are of importance for the design of the power drive system. To an increasing extent, it is the practice that power drive systems consist of components produced by different manufacturers. The object of this document is to explain, as far as possible, the influence of these components on the design of the electrical machine and its performance characteristics. This document deals with both AC electrical machines which are specifically designed for converter supply and converter-fed electrical machines within the scope of IEC 60034-12, which are designed originally for mains supply.
Scope: This part of IEC 60034 describes the performance characteristics of AC electrical machines for use on converter supplies. For electrical machines specifically designed for converter duty application design features are defined. It also specifies the interface parameters and interactions between the electrical machine and the converter including installation guidance as part of a power drive system, but except for the voltage at the power interface which is described in IEC TS 61800-8. The general requirements of relevant parts of the IEC 60034 series of standards also apply to electrical machines within the scope of this document. For electrical machines operating in potentially explosive atmospheres, additional requirements as described in the IEC 60079 series or IEC 61241 series for dust ignition proof apply. This document is not primarily concerned with safety. However, some of its recommendations may have implications for safety, which should be are considered as necessary. Where a converter manufacturer provides specific installation recommendations, they should take precedence over the recommendations of this document.
Contents:
- FOREWORD
- INTRODUCTION
- Scope