Electric vehicle conductive charging system - Part 26: EV supply equipment with automatic docking of a vehicle coupler located at the underbody of an electric vehicle
Introduction: This part of the IEC 61851 series provides requirements for EV supply equipment with automatic docking for the transfer of electric energy between EV supply equipment and electric road vehicles. The vehicle and the EV supply equipment make up a complete system that is covered by a number of IEC and ISO Standards. Automatic docking is indispensable for autonomous vehicles, and it is also helpful for disabled users of electric vehicles and for all users of electric vehicles seeking additional comfort. In the case of public electric vehicle supply equipment, automatic docking can also provide a convenient solution for queued vehicles, through automatic electric vehicle supply equipment that is either fully mobile or movable on rails. Automatic docking can increase the number of electric vehicles that are available to the grid to provide grid services. Within the IEC 61851 series, the following documents cover different aspects of automatic docking: IEC 61851-23-11: DC electric vehicle charging station with an automated connection device; IEC TS 61851-27: EV supply equipment with automatic docking of a vehicle coupler according to IEC 62196-2, IEC 62196-3 or IEC TS 62196-3-1; IEC TS 61851-282: Communication between EV supply equipment with automatic docking and vehicles. Automatic docking enables conductive energy transfer at the complete range of voltage and current as specified in the following documents: IEC 61851-1: general requirements, which is a system standard that serves
Scope: This document, in combination with IEC 61851-1 or IEC 61851-23, gives the requirements for EV supply equipment with automatic docking and undocking functions (aEVSE) at the underbody of electrically propelled road vehicles according to ISO TS 5474-5. Use of aEVSE with the megawatt charging system is under consideration. NOTE 1 Where this document refers to IEC 61851-23, it is intended to alternatively use IEC 61851-23-3. This document provides requirements for aEVSE with a single vehicle connector or a single socket-outlet. Requirements for aEVSE with more than one vehicle connector or more than one socket-outlet are under consideration. This document only applies to aEVSE with automatic couplers of category 3, located at the underbody of an electric vehicle. NOTE 2 Category 3 is planned to use the electro-mechanical interface for AC up to 22 kW defined by IEC TS 636444. Another document that extends category 3 and defines an electro-mechanical interface for combined AC/DC power transfer is under consideration. This document does not apply to aEVSE with automatic coupler of category 1, which use a vehicle coupler defined by IEC 62196-2, IEC 62196-3 or IEC TS 62196-3-1. NOTE 3 Category 1 is planned to also include the use of an electro-mechanical interface defined by IEC TS 633795. This document does not apply to aEVSE with automatic couplers of category 2, which use an electro-mechanical interface defined by EN 50696. EN 50696 also specifies automatic couplers located at the underbody of an electric vehicle. However, these couplers only provide DC power transfer. NOTE 4 Category 2 is planned to also include the use of an electro-mechanical interface defined by IEC 634076. EMC requirements for EV supply equipment are defined in IEC 61851-21-2. Interoperable communication for docking and undocking between an aEVSE and an EV, extending the communication between an EV supply equipment and an EV as specified in IEC 61851-1, IEC 61851-23, IEC 61851-24 and the ISO 15118 series, is under consideration. NOTE 5 Where this document refers to "interoperable communication for docking and undocking", it is intended to use communication according to IEC TS 61851-28. However, a
Contents:
- FOREWORD
- INTRODUCTION
- Scope