IEC TS 61967-3-2014 PDF

IEC TS 61967-3-2014 PDF

Integrated circuits-Measurement of electromagnetic emissions-Part 3: Measurement of radiated emissions-Surface scan method

$163.93 $327.86 -50%
Product Code: IEC TS 61967-3
Stock In Stock
Edition: 2.0
Published: 08/2014
Number of Pages: 78
File Size: 1 file, 1 Byte

Available Options

Product Description

Integrated circuits – Measurement of electromagnetic emissions – Part 3: Measurement of radiated emissions – Surface scan method

Introduction: 9.4 Measurement data 9.5 Post-processing 9.6 Data exchange Annex D – Coordinate systems c) Expansion of: 8.4 Test technique Annex A – Calibration of near-field probes The text of this technical specification is based on the following documents: Enquiry draft Report on voting 47A/925/DTS 47A/937/RVC Full information on the voting for the approval of this technical specification can be found in the report on voting indicated in the above table. This publication has been drafted in accordance with the ISO/IEC Directives, Part 2. A list of all parts in the IEC 61967 series, published under the general title Integrated circuits – Measurement of electromagnetic emissions, can be found on the IEC website. The committee has decided that the contents of this publication will remain unchanged until the stability date indicated on the IEC web site under "http://webstore.iec.ch" in the data related to the specific publication. At this date, the publication will be transformed into an International standard, reconfirmed, withdrawn, replaced by a revised edition, or amended. IMPORTANT – The 'colour inside' logo on the cover page of this publication indicates that it contains colours which are considered to be useful for the correct understanding of its contents. Users should therefore print this document using a colour printer.

Scope: This part of IEC 61967 provides a test procedure which defines an evaluation method for the near electric, magnetic or electromagnetic field components at or near the surface of an integrated circuit (IC). This diagnostic procedure is intended for IC architectural analysis such as floor planning and power distribution optimization. This test procedure is applicable to measurements on an IC mounted on any circuit board that is accessible to the scanning probe. In some cases it is useful to scan not only the IC but also its environment. For comparison of surface scan emissions between different ICs, the standardized test board defined in IEC 61967-1 should be used. This measurement method provides a mapping of the electric or magnetic near-field emissions over the IC. The resolution of the measurement is determined by the capability of the measurement probe and the precision of the probe-positioning system. This method is intended for use up to 6 GHz. Extending the upper limit of frequency is possible with existing probe technology but is beyond the scope of this specification. Measurements may be carried out in the frequency domain or in the time domain.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 61967-3-2014 PDF

IEC TS 61967-3-2014 PDF

$163.93 $327.86