Application integration at electric utilities - System interfaces for distribution management - Part 14: MultiSpeak - CIM harmonization
Introduction: This part of IEC 61968 seeks to address the need for harmonization between the two leading standards for software interoperability that serve the electric utility industry; MultiSpeakTM, which is maintained by the MultiSpeak Initiative, and the common information model (CIM), which is maintained by the International Electrotechnical Commission. While the CIM is an international standard, MultiSpeak has a significant footprint especially among municipal and cooperative utilities and vendors that serve these utilities, particularly in the United States. MultiSpeak is also used in fifteen countries worldwide. The goal of this technical specification is to harmonize the two standards so that the capability currently inherent in MultiSpeak could eventually be expressed as a profile within the CIM. To that end this particular effort will map V4.1x of MultiSpeak with IEC 61968-9:2009, Interfaces for meter reading and control of the CIM. This mapping will occur at the CIM profile level, so that each CIM profile will have a mapping to a corresponding element in MultiSpeak. This will serve two ends; (a) for those that need to translate from interfaces based on one standard to another, this mapping will give a roadmap for how that is accomplished, and (b) this exercise will reveal where alignment currently exists between the two standards and where gaps exist. As each standard goes through successive releases, reviews of business requirements which necessitated the respective releases a
Scope: This part of IEC 61968, which is a technical specification, explains how to do a mapping from CIM to MultiSpeak using an XML mapping tool, and the inclusion of an example project that gives practical guidance on the interoperability and mapping of source and destination applications through an ESB using an on demand meter read as the archetype. This technical specification will also cover the mapping of IEC 61968-9:2009 profiles to equivalent MultiSpeak v.4.1x message profiles. Each CIM profile will have a corresponding MultiSpeak profile with a prefix of “msp”. For example, CIM EndDeviceEvents matches the MultiSpeak mspEndDeviceEvents. The following profiles from IEC 61968-9:2009 are harmonized: AuxiliaryAgreementConfig CustomerAccountConfig CustomerAgreementConfig CustomerConfig CustomerMeterDataSet EndDeviceAssets EndDeviceControls EndDeviceEvents EndDeviceFirmware MeterAssetConfig MeterAssetReading MeterReadings MeterReadSchedule MeterServiceRequests MeterSystemEvents PricingStructureConfig ReceiptRecord SDPLocationConfig ServiceCategoryConfig ServiceDeliveryPointConfig ServiceLocationConfig SupplierConfig TransactionRecord Although the profiles will have some changes as part of the IEC 61968-9:2013, the scope of the harmonization effort for the 2nd edition to MultiSpeak v.5 (release candidate), will be IEC TS 61968-14:2015 IEC 2015 – 13 – limited to these same profiles. This will give the practitioner an ample set of mapping examples and allow them to make meaningful comparisons of the changes between IEC 61968-9:2009 and 2013 profiles and the respective mapping to MultiSpeak. This part of IEC 61968 contains the clauses listed in Table 1. Table 1 – Document overview for IEC 61968-14 Clause Title Purpose 1. Scope The scope and purpose of the document are described. 2. References (Normative) Documents that contain provisions which, through reference in this text, constitute provisions of this International Standard. 3. Terms, definitions, and abbreviations Establish the common terms used in this specification. 4. Reference and Information Models Description of general approach to metering system, reference model, use cases, interface reference model, meter
Contents:
- FOREWORD
- INTRODUCTION
- Scope