IEC TS 62033-2000 PDF

IEC TS 62033-2000 PDF

Attenuation Uniformity in Optical Fibres

$15.77 $31.53 -50%
Product Code: IEC TS 62033
Stock In Stock
Edition: 1.0
Published: 03/2000
Number of Pages: 24
File Size: 1 file, 74 Bytes

Available Options

Product Description

Attenuation Uniformity in Optical Fibres

Introduction: The attenuation coefficient of optical fibre and cable is measured over the entire length. It can vary locally within an overall length. When a length is cut into subsections, the attenuation coefficient of a subsection can be larger than the attenuation coefficient of the length from which it was cut. The attenuation uniformity measurement provides a characterization of the variance of the attenuation coefficient within an overall length. For cabled fibre, which is often cut to the length of use and measured, there is little value in attenuation uniformity measurements. For uncabled fibre, there are a number of strategies engaged to produce the maximum volume of low-attenuation cabled fibre. These strategies depend on many factors including mix of lengths and attenuation coefficient requirements on finished cable; mix of lengths and attenuation coefficients on uncabled fibre; inventory methods and available data; guard banding strategies that may be present for cable-induced attenuation.

Scope: This technical specification indicates the fundamental definitions for attenuation uniformity and outlines the algorithms used to compute attenuation uniformity values from backscattering measurements. Procedures for completing these measurements are given in IEC 60793-1-4-C1C.

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 62033-2000 PDF

IEC TS 62033-2000 PDF

$15.77 $31.53