IEC TS 62073-2016 PDF

IEC TS 62073-2016 PDF

Guidance on the measurement of hydrophobicity of insulator surfaces

$72.51 $145.02 -50%
Product Code: IEC TS 62073
Stock In Stock
Edition: 2.0
Published: 02/2016
Number of Pages: 24
File Size: 0 files

Available Options

Product Description

Guidance on the measurement of hydrophobicity of insulator surfaces

Introduction: The wetting properties of a surface by water are commonly described by the terms hydrophobic (or hydrophobicity) and hydrophilic (or hydrophilicity). A hydrophobic surface is water-repellent, while a surface that is easily wetted by water is hydrophilic. The wetting phenomenon of a surface is complex and many different parameters can influence its hydrophobic properties. Some important parameters include: type of insulator material, surface roughness, heterogeneities of the surface, chemical composition (e.g. due to ageing) and presence of pollution. For insulator materials in common use, the hydrophobic properties can change over time, due to the influence of the ambient conditions. This change can be either reversible or irreversible. Thus, the result of the measurement of the hydrophobicity may be influenced by the ambient conditions and the HV corona or dry-band arcing to which the insulator has been previously exposed. This dynamic behaviour of the hydrophobicity is more or less specific to different insulator materials. These types of materials, which have an ability to retain and transfer hydrophobicity, are commonly called Hydrophobicity Transfer Materials (HTM). The dynamic behaviour of the hydrophobicity exhibited by insulator materials is due to their chemical composition. Different processes such as oxidation, hydrolysis, migration of low molecular weight compounds, formation of complex compounds between e.g. siloxanes and water, rotation of flexible polymer chain

Scope: The methods described in this technical specification can be used for the measurement of the hydrophobicity of the shed and housing material of composite insulators for overhead lines, substations and equipment or ceramic insulators covered or not covered by a coating. The obtained value represents the hydrophobicity at the time of the measurement. The object of this technical specification is to describe three methods that can be used to determine the hydrophobicity of insulators. The determination of the ability of water to wet the surface of insulators may be useful to evaluate the condition of the surface of insulators in service, or as part of the insulator testing in the laboratory. Terms and definitions For the purposes of this document, the following definitions apply. 2.1 hydrophobicity state of a surface with a low surface tension and thus is water-repellent 2.2 hydrophilicity state of a surface with a high surface tension and thus is wetted by water (in the form of a film) 2.3 surface tension region of finite thickness (usually less than 0,1 µm) in which the composition and energy vary continuously from one bulk phase to the other Note 1 to entry: The pressure (force field) in the interfacial zone has a gradient perpendicular to the interfacial boundary. A net energy is required to create an interface (surface) by transporting the matter from the bulk phase to the interfacial (surface) zone. The reversible work required to create a unit interfacial (surface) area is the surface tension and is defined thermodynamically as follows: T,P,n G  where is the surface (interfacial) tension or surface energy; is the Gibbs free energy of the total system; is the surface (interfacial) area; is the temperature; is the pressure; is the total number of moles of matter in the system. The surface tension (γ) is usually expressed in mN/m (1 mN/m = 1 dyn/cm).

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 62073-2016 PDF

IEC TS 62073-2016 PDF

$72.51 $145.02