IEC TS 62196-3-1-2020 PDF

IEC TS 62196-3-1-2020 PDF

Plugs, socket-outlets, vehicle connectors and vehicle inlets-Conductive charging of electric vehicles-Part 3-1: Vehicle connector, vehicle inlet and cable assembly for DC charging intended to be used with a thermal management system

$239.59 $479.18 -50%
Product Code: IEC TS 62196-3-1
Stock In Stock
Edition: 1.0
Published: 03/2020
Number of Pages: 66
File Size: 1 file, 4 Bytes

Available Options

Product Description

Plugs, socket-outlets, vehicle connectors and vehicle inlets – Conductive charging of electric vehicles – Part 3-1: Vehicle connector, vehicle inlet and cable assembly for DC charging intended to be used with a thermal management system

Introduction: Responding to global challenges of CO2 reduction and energy safety, the automobile industries have been accelerating the development and commercialization of electric vehicles (EV) and hybrid electric vehicles. In addition to the prevailing hybrid electric vehicles, battery electric vehicles including plug-in hybrid electric vehicles are going to be mass-marketed. To support the diffusion of such vehicles, this document provides the standard interface configurations of vehicle couplers and accessories to be used in conductive charging of electric vehicles, taking the most frequent charging situations into consideration. To meet the market demand for increased electric vehicle ranges, batteries with larger capacities need to be integrated. To charge those batteries with larger capacity in similar times as existing charging times or even faster, the charging power needs to be increased. Besides increasing the charging voltage, the charging current also needs to be increased to boost the charging power. The larger charging current implies either larger conductor cross sections for the cable assembly according to existing standards or additional measures in the cable assembly. The large conductor cross sections that are required according to the existing design requirements and test methods result in significantly thicker and heavier cable assemblies. These are difficult to handle and thus less desirable for public use. Therefore, to improve the usability of charging systems this

Scope: This document applies to accessories and cable assemblies with the same configuration as specified in IEC 62196-3:2014 with rated operating voltage not exceeding 1 500 V DC and a rated current not exceeding 500 A that employ thermal sensing, or thermal transport and thermal sensing with the system architecture described in 4.101. These accessories and cable assemblies are intended to be used in conductive charging systems for circuits specified in IEC 61851-23. NOTE Edition 2 of IEC 61851-23 is under development. The accessories covered by this document are intended to be used in charging mode 4 according to IEC 61851-1. These accessories are intended to be connected to cables according to the IEC 62893 series for DC cables.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 101 Liquid coolants

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 62196-3-1-2020 PDF

IEC TS 62196-3-1-2020 PDF

$239.59 $479.18