IEC TS 62257-9-2-2016 PDF

IEC TS 62257-9-2-2016 PDF

Recommendations for renewable energy and hybrid systems for rural electrification-Part 9-2: Integrated systems-Microgrids

$163.93 $327.86 -50%
Product Code: IEC TS 62257-9-2
Stock In Stock
Edition: 2.0
Published: 09/2016
Number of Pages: 44
File Size: 1 file, 1 Byte

Available Options

Product Description

Recommendations for renewable energy and hybrid systems for rural electrification – Part 9-2: Integrated systems – Microgrids

Introduction: The IEC 62257 series intends to provide to different players involved in rural electrification projects (such as project implementers, project contractors, project supervisors, installers, etc.) documents for the setting up of renewable energy and hybrid systems with a.c. nominal voltage below 1 000 V and d.c. nominal voltage below 1 500 V. These documents are recommendations: to choose the right system for the right place, to design the system, to operate and maintain the system. These documents are focused only on rural electrification concentrating on but not specific to developing countries. They should not be considered as all inclusive to rural electrification. The documents try to promote the use of renewable energies in rural electrification; they do not deal with clean mechanisms developments at this time (CO2 emission, carbon credit, etc.). Further developments in this field could be introduced in future steps. This consistent set of documents is best considered as a whole with different parts corresponding to items for safety, sustainability of systems and at the lowest life cycle cost as possible. One of the main objectives is to provide the minimum sufficient requirements, relevant to the field of application that is: small renewable energy and hybrid off-grid systems. Decentralized Rural Electrification Systems (DRESs) are designed to supply electric power for sites which are not connected to a large interconnected system, or a national grid, in order to meet ba

Scope: This part of IEC 62257, which is a technical specification, specifies the general requirements for the design and the implementation of microgrids used in decentralized rural electrification to ensure the safety of persons and property and their satisfactory operation according to the scheduled use. This part of IEC 62257 applies to microgrids for decentralized rural electrification purposes. The microgrids covered by this part of IEC 62257 are low voltage a.c., three-phase or single- phase, with rated capacity less than or equal to 100 kVA. They are powered by a single micropower plant and do not include voltage transformation. The rated capacity is at the electrical output of the micropower plant, that is, the upstream terminals of the main switch between the micropower plant and the microgrid. The voltage levels covered under this specification are voltages of the 240 V 1-Ø/415 V 3-Ø, the 230 V 1-Ø/400 V 3-Ø, the 220 V 1-Ø/380 V 3-Ø, and the 120 V 1-Ø/208 V 3-Ø systems at 60 Hz or 50 Hz; or obeyed by local code. This part of IEC 62257 specifies microgrids made of overhead lines because of technical and economical reasons in the context of decentralized rural electrification. In particular cases, underground cables can be used. The requirements cover microgrids with radial architecture.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 62257-9-2-2016 PDF

IEC TS 62257-9-2-2016 PDF

$163.93 $327.86