Categorization of optical devices
Introduction: IEC/TS 62538, which is a technical specification, is based on the conclusions of the coordinating group on categorization, approved by TC86 in 2005 and 2006, with the aim to allocate the various optical devices among the appropriate working groups. It contains fundamental definitions of broad validity and the procedure to categorize any optical devices.
Scope: IEC/TS 62438, which is a technical specification, applies to optical devices (i.e. elements, components, assemblies, sub-assemblies or modules) of interest to TC86 and its subcommittee. It provides the definitions of the three main categories of optical devices (i.e. dynamic, active and passive) together with other related definitions. It also gives a general procedure to identify the category of any optical devices. Terms and definitions For the purposes of this document, the following terms and definitions apply. NOTE 1 The definitions given in 2.1 are determined for the three main categories of optical devices: “optical dynamic devices,” “optical active devices” and “optical passive devices.” Other supporting definitions are given in 2.2 and concern the term “optical device” and the related terms “optical element,” “optical component,” “optical assembly,” “optical sub-assembly” and “optical module.” The categorization criteria leading to the definitions of 2.1 are reported in Annex A. NOTE 2 Some definitions reported in IEC 61931, analogous to those given in this clause, are superseded by the present technical specification. NOTE 3 The terms optical (or fibre optic) “system” and “subsystem” as defined in IEC 61281-1 do not describe an optical device (according to the definitions given in this clause) and are outside the scope of this technical specification. The use of these two terms to indicate optical assemblies, sub-assemblies or modules is deprecated. 2.1 Categorization of main definitions 2.1.1 optical dynamic device optical device designed to monitor and control dynamically some characteristics of one or more optical signals, by means of suitable electronic controls, in order to improve or to maintain definite performances of the system in which it is intended to be inserted NOTE 1 Said characteristics may include optical paths, optical intensities, spectrum characteristics, polarization states, dispersion, etc. NOTE 2 Optical dynamic devices may comprise optical active and optical passive elements or components. NOTE 3 The control/response time of optical dynamic devices is much larger than the signal time characteristics and typically may range from
Contents:
- FOREWORD
- INTRODUCTION
- Scope