Nanomanufacturing - Product specification - Part 3-6: Graphene-related products – Blank detail specification: graphene oxide in powders and dispersions
Introduction: This document establishes a standardized method to specify graphene-based materials of the type of graphene oxide in form of powder and powders dispersed in liquids. Commercially available graphene oxide differs in multiple ways from the perfect graphene oxide structure as described in the correct academic definition as a monolayer of an oxidized honeycomb arrangement of carbon atoms with a carbon-to-oxygen (C/O) ratio of 2,0. Typical application areas of graphene oxide are coatings, filters, drug carriers, bio-sensors, and functional fabrics. A quite common way to synthesise graphene oxide is the processing of graphite in concentrated acid in the presence of an oxidizing agent to exfoliate the graphene layers. Depending on the application, graphene oxide is made available as dry powder and liquid dispersion, e.g. in water. The structure of graphene oxide strongly depends on the method of synthesis. The graphene oxide flakes have various types of small and large defects. Beside the oxygen bound to both sides of the carbon monolayer, it is typically decorated with different types of oxygen containing functional groups. Subtle differences in the physical structure cause large differences in electrical, optical, and chemical properties of graphene oxide. Therefore, it is important that vendors and users specify the material as precisely as possible. A clear understanding and precise definition of these key control characteristics (KCCs) as well as the availability of standardize
Scope: This part of IEC 62565 establishes the blank detail specification for graphene oxide in powders and aqueous dispersions. This document defines a format for specifying key control characteristics (KCCs), including a list of these characteristics and their corresponding standardized measurement procedures, where available. Numeric values are left blank to be determined between the customer and supplier in the detail specification (DS). In the DS, key control characteristics can be added or removed by mutual agreement. If no standardized measurement procedures are available, guidelines in Annex A are presented, which can be used by the involved parties to assure consistent material quality. For non-aqueous solvents, it is crucial to make modifications to address relevant characteristics such as appearance, pH, and viscosity.
Contents:
- FOREWORD
- INTRODUCTION
- Scope