IEC TS 62607-3-2-2017 PDF

IEC TS 62607-3-2-2017 PDF

Nanomanufacturing-Key control characteristics-Part 3-2: Luminescent nanoparticles-Determination of mass of quantum dot dispersion

$50.44 $100.88 -50%
Product Code: IEC TS 62607-3-2
Stock In Stock
Edition: 1.0
Published: 01/2017
Number of Pages: 18
File Size: 1 file, 259 Bytes

Available Options

Product Description

Nanomanufacturing – Key control characteristics – Part 3-2: Luminescent nanoparticles – Determination of mass of quantum dot dispersion

Introduction: Quantum dots (QDs) are crystals of semiconductor materials measuring typically but not limited to 2 nm to 15 nm in a given dimension and could exhibit desirable absorption and emission properties. QDs can be synthesized by a variety of methods, the colloidal method being the most common. Through the colloidal method, QDs are synthesized in the presence of stabilizing ligands to maintain colloidal stability. These ligands can remain present after purification and are an important component of QD dispersibility and stability and can impact the optical properties. Often, QD samples are provided as a stable dispersion instead of a dried powder. The method specified in this document provides a means to determine the mass of QDs in that dispersion. In addition to the semiconductor material and the tightly bound stabilizing ligands, QD dispersions could potentially contain unreacted precursors, side-products of the precursors, and free ligands. Due to the difficulty of removing and determining the amount of these impurities, the dried mass is not sufficient for measuring QD mass. Instead, a method is chosen that will remove or decompose the impurities while leaving the semiconductor material intact. One method to volatilize or decompose the impurities and surfactant ligands is by heating the QD sample to high temperatures (650 °C). Heating QD samples to such high temperatures is typically destructive to the QD sample, so this analysis would need to be performed on a small portion th

Scope: This part of IEC 62607 specifies a method for determining the mass of a sample of QD dispersion after the removal of impurities and surfactant ligands through heating at high temperatures.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 62607-3-2-2017 PDF

IEC TS 62607-3-2-2017 PDF

$50.44 $100.88