Nanomanufacturing – Key control characteristics – Part 6-1: Graphene-based material – Volume resistivity: four probe method
Introduction: Graphene has attracted great interest as a next generation electronic material due to its extremely high mobility and ballistic transport of electrons [1] 1. The unique properties of graphene enable it to be an effective candidate used in electronic products such as transparent conducting films, sensors, field emitters, supercapacitors, etc. Characterization of the electrical properties of graphene itself is essential to both manufacturers and users in order to develop innovative electronic devices or to improve existing electronic devices using it. Commercialized graphene products can be categorized by their manufacturing methods as follows: (i) graphene flakes and/or nanoplatelets in powder form (hereinafter called GNP), (ii) graphene sheets suspended in liquids or (iii) graphene films grown by chemical vapour deposition (CVD). Many electrical properties of a powder-type graphene product are significantly affected by its geometric and electronic parameters [2]. First, it is required to select the parameter that best represents the quality of the graphene products. Second, a suitable sample preparation for the purpose of electrical measurements is also elucidated and described. Finally, measurement conditions are also crucial factors to determine the representative value of the powder product in terms of its electrical properties. Among the measurands in determining electronic properties of powder-type graphene – sheet resistance (or conductance), resistivity (or conductivit
Scope: This part of IEC TS 62607 establishes a standardized method to determine the electrical key control characteristic volume resistivity for powder consisting of graphene-based material like flakes of graphene, few layer graphene and/or reduced graphene oxide after preparation of a sample in pellet form by four probe method using powder resistivity measurement system. The volume resistivity is a measure of the quality of powder-type graphene products in terms of electrical property and reflects the density-dependency shown in a pellet of powder-type graphene. The volume conductivity can directly be derived from the volume resistivity. Typical application areas are industries that use powder-type graphene products for graphene manufacture, potential developers, and users who produce graphene-based products. As the volume resistivity measured according to this document requires the preparation of a sample in the form of a pellet, this document describes in detail an apparatus to prepare consistently a test sample, the pellet, the preparation of the pellet starting from powder-type graphene, the measurement procedure to measure the volume resistivity (or volume conductivity) of the pellet, and the data analysis, the interpretation and reporting of the results.
Contents:
- FOREWORD
- INTRODUCTION
- Scope