IEC TS 62607-6-26-2025 PDF

IEC TS 62607-6-26-2025 PDF

Nanomanufacturing - Key control characteristics - Part 6-26: Graphene-related products - Fracture strain and stress, Young’s modulus, residual strain and residual stress: bulge test

$132.41 $264.81 -50%
Product Code: IEC TS 62607-6-26
Stock In Stock
Edition: 1.0
Published: 12/2025
Number of Pages: 30
File Size: 1 file, 2 Bytes

Available Options

Product Description

Nanomanufacturing - Key control characteristics - Part 6-26: Graphene-related products - Fracture strain and stress, Young’s modulus, residual strain and residual stress: bulge test

Introduction: When the characteristic dimensions of materials are reduced to the nanoscale regime, their mechanical properties exhibit significant changes compared to their bulk counterparts. These changes include enhancements in elasticity, residual strain, and fracture resistance, which are critical for reliable and high-performance nanoscale devices. Low-dimensional materials, such as graphene and nanometre-thick films, have gained widespread attention because of their exceptional thermal, optical, electrical, and mechanical properties. These unique characteristics make them indispensable in the development of advanced nanoscale technologies. The mechanical properties of two-dimensional (2D) materials, such as Young's modulus (or elastic modulus), residual strain, residual stress, and fracture stress, are essential for their integration into diverse applications. As shown in Figure 1, these properties are utilized in several applications. These include a) strain sensors for precise mechanical deformation detection, b) energy harvesting devices using piezoelectric effects to convert mechanical to electrical energy, c) vibrational acoustic applications supporting sound generation or absorption, and d) pellicle membranes for EUV lithography that maintain structural stability under high thermal and mechanical stresses during device operation [1]1, [2], [3], [4], [5]. These applications highlight the versatility of mechanical properties in enabling innovative engineering solutions at the nan

Scope: This part of IEC TS 62607 establishes a standardized method to determine the mechanical key control characteristics (KCCs) Young's modulus (or elastic modulus), residual strain, residual stress, and fracture stress of 2D materials and nanoscale films using the bulge test. The bulge test is a reliable method where a pressure differential is applied to a freestanding film, and the resulting deformation is measured to derive the mechanical properties. This method is applicable to a wide range of freestanding 2D materials, such as graphene, and nanometre-thick films with thicknesses typically ranging from 1 nm to several hundred nanometres. This document ensures the characterization of mechanical properties essential for assessing the structural integrity and performance of materials in applications such as composite additives, flexible electronics, and energy harvesting devices.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 62607-6-26-2025 PDF

IEC TS 62607-6-26-2025 PDF

$132.41 $264.81