Nanomanufacturing - Key control characteristics - Part 6-28: Graphene-related products - Number of layers for graphene films on a substrate: Raman spectroscopy
Introduction: Graphene-related products have appealing performance in electrical, optical, mechanical and thermal properties, which have aroused widespread interests in both academic and industrial communities. The number of layers of graphene-related products is one of the key control characteristics (KCCs) affecting their performance. Therefore, the accurate measurement of the number of layers is a critical issue in related research and applications. Raman spectroscopy is a fast, non-destructive and highly sensitive characterization tool used in graphene-related research. The most prominent Raman peaks in graphene layers are the D-peak (∼1 350 cm−1), the G-peak (∼1 580 cm−1), and the 2D-peak (also known as the G’-peak, ∼ 2 700 cm−1, which depends on the excitation energy and number of layers). Their peak positions, peak intensities and peak shapes can be used to determine the number of layers [1]1. For example, the intensity ratio of 2D-peak and G-peak (I2D/IG) of roughly 2 or higher provides a good identification of monolayer graphene. As the number of graphene layers increasing, the I2D/IG ratio decreases rapidly. As for multilayer graphene layers with Bernal stacking (AB stacking) and rhombohedral stacking (ABC stacking) prepared by mechanical exfoliation, the spectral characteristics of their Raman peaks show certain relationships with the number of layers. For example, the 2D-peak of graphene-related products with AB stacking less than 5 layers has a distinctive peak shape that is r
Scope: This part of IEC 62607 establishes two standardized methods to determine the key control characteristic number of layers for graphene layers by Raman spectroscopy. This document presents two complementary methods for determining the number of layers in graphene-related products: Method A, which analyzes the lineshape of the 2D-peak in the Raman spectrum, and Method B, which measures the Raman intensity from the underlying silicon substrate. The two methods can be employed individually but combining both methods enhances accuracy and extends the detection range for the number of layers and stacking configurations. The method is intended to be used for graphene layers prepared by mechanical exfoliation, but also can be used with care for other high quality graphene layers, such as graphene layers prepared by chemical vapor deposition. The method can be used for graphene layers with AB and ABC stacking on a substrate. Its lateral size should be at least 2 µm. Method A is effective for AB stacked graphene up to 4 layers but becomes less reliable with more layers due to peak overlap. Method B can detect up to 10 layers in AB and ABC stacking but oxidized silicon substrate (SiO2 on silicon substrate) is required. The comparison of Method A and Method B can be found in Annex A.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 532 nm