Nanomanufacturing - Key control characteristics - Part 6-36: Graphene-related products - Reduction status of graphene oxide and reduced graphene oxide: UV-Vis absorption spectroscopy
Introduction: Metallic van der Waals materials composed of a monolayer have recently drawn interest as a potential and adaptable application platform in a variety of industrial applications (electronics, optoelectronics, and energy storage devices). Because of its lower energy level, strong electrical and thermal conductivity, and high transparency due to its atomic thickness, graphene is among the most attractive possibilities for metallic van der Waals materials.[1]1 Chemical vapour deposition is a typical bottom-up approach, which is widely accepted as an effective synthetic method for producing monolayer graphene. The approach is very well suited for nano-structuring and obtaining superior monolayer graphene. However, to advance toward genuinely practical methods for commercialization, several issues are still to be addressed, such as the long synthesis time, high-temperature heat treatment, and the requirement for additional post-transfer-process, which limit the scalability and production of graphene. For the mass manufacturing of graphene, a solution-based direct reduction technique (top-down) has been taken into consideration. Graphene oxide (GO) can be converted into graphene using a variety of reducing substances and solutions. To perfectly replicate the remarkable properties of graphene, it is important that the level of oxygen functionalization in GO be lowered or eliminated. A subsequent transformation of GO into reduced graphene oxide (rGO) can be performed to induce the π-π
Scope: This part of IEC 62607 establishes a standardized method to determine the key control characteristic reduction status for graphene oxide (GO) and reduced graphene oxide (rGO) by ultraviolet-visible spectroscopy (UV-Vis). The reduction status is not a quantitative value, but rather a compilation (table) of six parameters extracted from UV-Vis absorption spectra. These six parameters can be obtained from GO and rGO as follows: (1) the peak location of GO, (2) the shoulder peak of GO, (3) the full width at half maximum (FWHM) of the main absorption peak of GO, (4) the peak location of rGO, (5) FWHM of the main absorption peak of rGO and (6) the spectral peak shifts between GO and rGO. The method is applicable to the characterization of GO and rGO materials (where rGO is obtained from the corresponding GO) produced by different reduction techniques, as well as to commercial products in solution or film form. Individual GO or rGO materials can also be characterized, but only partial parameters can be obtained. Specifically, peak location, FWHM, and shoulder peak can be measured from each GO or rGO material, while peak shift requires both GO and its corresponding rGO for comparison. The method is suitable for quality assurance and for monitoring the reduction process during the production of rGO. The method does not provide full chemical analysis. Complementary techniques can be required beyond the UV-Vis spectral features.
Contents:
- FOREWORD
- INTRODUCTION
- Scope