IEC TS 62607-6-9-2022 PDF

IEC TS 62607-6-9-2022 PDF

Nanomanufacturing-Key control characteristics-Part 6-9: Graphene-based material-Sheet resistance: Eddy current method

$132.41 $264.81 -50%
Product Code: IEC TS 62607-6-9
Stock In Stock
Edition: 1.0
Published: 02/2022
Number of Pages: 30
File Size: 1 file, 2 MB

Available Options

Product Description

Nanomanufacturing – Key control characteristics – Part 6-9: Graphene-based material – Sheet resistance: Eddy current method

Introduction: The application of graphene and graphene-related materials as a conductive large-area electrode material has become of rising interest during recent years. Especially in the application of graphene as a replacement material for indium tin oxide (ITO), graphene combines low sheet resistance and high optical transparency. In particular, the application of optically transparent large-area graphene layers has become more important. Hence, the electrical characterization of large-area graphene layers is essential. However, contacting methods, such as four-probe measurements, can cause damage to the graphene and deteriorate its quality. Non-contact methods have advantages for measurement of the sheet resistance since damage to the layers is avoided and it is possible to readily scan the film to examine homogeneity. The sheet resistance can serve as a measure for the electrical characterization due to its direct dependence on conductivity and graphene quality for electrical applications.

Scope: This part of IEC 62607 establishes a standardized method to determine the key control characteristic sheet resistance for films of graphene-based materials by eddy current method. With this method a coil-generated primary alternating electromagnetic field induces eddy currents in the conducting layer to be measured. The superposition of the primary field with the secondary field induced by the eddy currents is a function of the sheet resistance of the layer. The method is applicable for the contactless measurement of the sheet resistance of large area graphene layers on non-conductive substrates. As the method avoids any physical contact, it prevents any mechanical damage to the sensitive graphene layer. Therefore, the method is suitable for electrical characterization and quality control in an industrial fabrication environment. Due to the use of two detectors – one above the substrate and one below the substrate – the method is insensitive regarding small deviations from perfect flatness of the substrate. The range of graphene layers to be characterized comprises any quality, size and morphology of graphene crystallites. Hence, the applicability of this method spans from high quality, defect-free graphene layers to layers of dried graphene ink. The size of the graphene layers to be characterized includes layers larger than 25 mm × 25 mm for single point testing and 50 mm × 50 mm for imaging testing. The method can be used for layers of graphene-based material with a sheet resistance in the nominal range of 10 Ω/sq to 5 000 Ω/sq.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 62607-6-9-2022 PDF

IEC TS 62607-6-9-2022 PDF

$132.41 $264.81