IEC TS 62642-7-2011 PDF

IEC TS 62642-7-2011 PDF

Alarm systems-Intrusion and hold-up systems-Part 7: Application guidelines

$211.22 $422.43 -50%
Product Code: IEC TS 62642-7
Stock In Stock
Edition: 1.0
Published: 02/2011
Number of Pages: 58
File Size: 1 file, 394 Bytes

Available Options

Product Description

Alarm systems – Intrusion and hold-up systems – Part 7: Application guidelines

Introduction: This part 7 of the IEC 62642 series of standards gives requirements for intrusion and hold-up alarm systems. The other parts of this series of standards are as follows: Part 1 System requirements Part 2-2 Intrusion detectors – Passive infrared detectors Part 2-3 Intrusion detectors – Microwave detectors Part 2-4 Intrusion detectors – Combined passive infrared / microwave detectors Part 2-5 Intrusion detectors – Combined passive infrared / ultrasonic detectors Part 2-6 Intrusion detectors – Opening contacts (magnetic) Part 2-71 Intrusion detectors – Glass break detectors – Acoustic Part 2-72 Intrusion detectors – Glass break detectors – Passive Part 2-73 Intrusion detectors – Glass break detectors – Active Part 3 Control and indicating equipment Part 4 Warning devices Part 5-3 Interconnections – Requirements for equipment using radio frequency techniques Part 6 Power supplies Part 7 Application guidelines Part 8 Security fog devices/systems In order to insure the consistency of the whole IEC 62642 series, the terminology is defined at one place that is the master document IEC 62642-1 that gives general requirements concerning the intrusion system. Exception is made for specific terms to installation and where repetition is deemed essential for the clarity of this document. A number of requirements are contained in this standard for which a formal test procedure can only be written by defining (and hence restricting) the technology by which the requirement is achieved. Accordin

Scope: This Technical Specification provides guidance on the design, planning, operation, installation, commissioning and maintenance of intrusion and hold-up alarm system (I&HAS) installed in buildings. Requirements for I&HAS are specified in IEC 62642-1:2010. The recommendations of this Technical Specification (TS) also apply to intruder alarm system (IAS) and hold-up alarm system (HAS) when these systems are installed independently. When an I&HAS does not include functions relating to the detection of intruders, the requirements relating to intrusion detection do not apply. When an I&HAS does not include functions relating to hold-up, the requirements relating to hold-up do not apply. NOTE 1 Unless otherwise stated, the abbreviation I&HAS is also intended to mean IAS and HAS. These application guidelines are intended to assist those responsible for establishing an I&HAS to ascertain the appropriate design of I&HAS both in terms of the extent of the supervision required and in determining the grade of system performance necessary to provide the degree of supervision considered appropriate. These application guidelines are also intended to assist those responsible for selecting equipment appropriate to both the level of performance required and the environmental conditions in which the equipment will be required to operate. These application guidelines are relevant to all classes and grades of I&HAS of any size and complexity. These application guidelines should be read in conjunction with IEC 62462- 1:2010. NOTE 2 It has been assumed in the drafting of these application guidelines that the execution of its provisions will be entrusted to appropriately qualified and experienced persons. However, the guidance is also appropriate to other persons who may be required to purchase or use an I&HAS.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 6.10 Compatibility
  • 7.3.10 Response to I&HAS

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 62642-7-2011 PDF

IEC TS 62642-7-2011 PDF

$211.22 $422.43