IEC TS 62788-6-3-2022 PDF

IEC TS 62788-6-3-2022 PDF

Measurement procedures for materials used in photovoltaic modules-Part 6-3: Adhesion testing for PV module laminates using the single cantilevered beam (SCB) method

$163.93 $327.86 -50%
Product Code: IEC TS 62788-6-3
Stock In Stock
Edition: 1.0
Published: 08/2022
Number of Pages: 36
File Size: 1 file, 2 Bytes

Available Options

Product Description

Measurement procedures for materials used in photovoltaic modules – Part 6-3: Adhesion testing for PV module laminates using the single cantilevered beam (SCB) method

Introduction: This document describes the single cantilevered beam (SCB) test, useful for characterizing adhesion in photovoltaic (PV) modules. This method is grounded in fundamental concepts of beam and fracture mechanics [1]1, [4], and allows for a quantitative measurement of adhesion strength. A method for calculating the debond length, af, has been developed as an option to physical measurement. PV modules are multi-layer structures that depend on adequate adhesion between each layer to ensure their reliable operation. Adhesion testing is described in current IEC PV standards for module safety qualification (IEC 61730-2) and component characterization (IEC 62788 series). The most commonly used tests are peel tests at either 180° for components (IEC TS 62788-2 test and IEC 62788-1-1), or at 90° for modules (IEC 61730-2 MST 35). Peel tests are in practice simple to carry out, and provide a peel strength value, different from adhesion strength. Viscoelastic properties of the polymeric material and the mechanics of the pull tab have a strong influence on the result, making these tests of limited value in comparing either different materials, or the same material after stress exposures. In the SCB method, an elastic width-tapered cantilever beam is adhered to the sample. When the beam is loaded at its apex, delamination will initiate at the weakest interface and advance upon continued loading. This measurement allows for calculation of the critical value of the energy release rate, Gc, whic

Scope: This part of IEC TS 62788 provides a method for measuring the adhesion energy of most interfaces within the photovoltaic (PV) module laminate. In contrast to other adhesion tests in general use, this method provides a measure of adhesive energy, via the critical energy release rate, and so is more useful for comparing adhesion of different specimen types; e.g. different materials, module or coupon samples, or materials before and after stress exposure. This is a “weakest link” test, meaning that the weakest interface is the one most likely to fail in a given test. Adhesion of a specific layer may be difficult to intentionally measure if there is a weaker interface in the system.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 62788-6-3-2022 PDF

IEC TS 62788-6-3-2022 PDF

$163.93 $327.86