IEC TS 62788-8-1-2024 PDF

IEC TS 62788-8-1-2024 PDF

Measurement procedures for materials used in photovoltaic modules-Part 8-1: Electrically conductive adhesive (ECA)-Measurement of material properties

$211.22 $422.43 -50%
Product Code: IEC TS 62788-8-1
Stock In Stock
Edition: 1.0
Published: 06/2024
Number of Pages: 56
File Size: 1 file, 2 Bytes

Available Options

Product Description

Measurement procedures for materials used in photovoltaic modules – Part 8-1: Electrically conductive adhesive (ECA) – Measurement of material properties

Introduction: Electrically conductive adhesive (ECA) is a material composed of conductive fillers blended with an organic adhesive polymer matrix. Already widely used as an interconnect material in electronic packaging and interconnection technologies for electronic devices, ECA is beginning to replace metallic solders as an innovative interconnection method in recent designs of photovoltaic (PV) modules. In a typical shingled PV module, solar cells are cut into strips and these solar cell strips overlap each other. ECA is applied in between the top electrode of one cell strip and the bottom electrode of the adjacent cell strip to form the electric interconnection. In some back-contact PV module designs, ECA allows the interconnection of solar cells’ rear busbars to a conductive backsheet. In some PV modules where the solar cells are sensitive to high soldering temperatures, ECA is used to connect PV ribbons to the electrodes of the solar cells. The solar cell interconnections based on ECA can effectively reduce mechanical stress, shading loss and interconnect ohmic loss, and have been profiled as a promising alternative to traditional soldering process. ECA can be used for wiring and surface assembly in PV modules. Initial performance and environmental endurance in application are highly dependent on its inherent material characteristics. For instance, adhesive properties are the primary requirement for ECA. Good adhesion between ECA and the adherends enables the structural integrity and

Scope: This document defines test methods and datasheet reporting requirements for key characteristics of ECA used in photovoltaic modules, involving mechanical characteristics, adhesive characteristics, electrical characteristics, thermal characteristics, etc. The object of this document is to offer a standard test procedure to ECA manufacturers for product design, production and quality control, and to PV module manufacturers for the purpose of material screening, material inspection, process control, and failure analysis. This document is intended to be applied to ECA used in solar PV modules. For non-conductive adhesives or tapes used in PV modules, the applicable test methods except for electrical characteristics in this document may be used.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC TS 62788-8-1-2024 PDF

IEC TS 62788-8-1-2024 PDF

$211.22 $422.43